100425 Gen4 Double Tube Bumper Winch Mount
Product Information
Product Name: PolARIs Gen 4 Double Tube buMPeR Winch Mount
Part Number: 100425
Kit Components:
| Item # | Qty. | Description |
|---|---|---|
| 1 | 1 | Winch Mount |
| 2 | 1 | HK-002 |
| 2.1 | 4 | M8-1.25 X 1.00 Flat Head Cap screw |
| 2.2 | 4 | 5/16-18 X 1.00 Hex nut nylock GR5 |
| 2.3 | 4 | 5/16 Flat Washer |
| 2.4 | 4 | 5/16-18 Hex nut nylock GR5 |
| *2.5 | 4 | *5/16-18 X 1.00 Flat Head Cap screw – not used |
Product Usage Instructions
- If your bumper is already installed on your ATV, remove
it. - Connect the winch motor wires to your winch.
- Assemble the winch to the mount plate using the supplied Flat
Head screws (refer to Figure 1). - Assemble your roller or hawse fairlead to your bumper using the
hardware supplied with your winch. - Assemble the winch and mount assembly to the bumper using the
supplied 5/16 hardware (refer to Figure 2 and 3). At the same time,
feed your cable through the Roller or Hawse Fairlead.
Figure 3 - Reassemble the bumper to your ATV.
- Follow the instructions provided with your winch for wiring
accordingly.
Note: Make sure all hardware needed to complete this mount is in
the package. Thoroughly read through and understand the
instructions before installing.
Date of Manual: 06/09/23
PolARIs Gen 4 Double Tube buMPeR
Winch Mount PART #100425
Kit Components:
Figure 1
Item # Qty.
Description
1
1
1 Winch Mount
2
1 HK-002
2.1 4 M8-1.25 X 1.00″ Flat Head Cap screw
2.2 4 5/16″-18 X 1.00″ Hex nut nylock GR5
2.3 4 5/16″ Flat Washer
2.4 4 5/16″-18 Hex nut nylock GR5
*2.5 4 *5/16″-18 X 1.00″ Flat Head Cap screw – not used
2.1
Note: Make sure all hardware needed to complete this mount is in the
package. Thoroughly read through and understand the instructions
before installing.
winch cable
Installation Instructions
Figure 2 1. If your bumper is already installed you will need to remove it
1
from your ATV.
2. Connect the winch motor wires to your winch and then assemble the winch to the mount plate as shown in Figure 1 using the supplied Flat Head screws.
· NOTE: Also make sure you pull your cable through the cable hole in the plate.
3. Assemble your roller or hawse fairlead to your bumper with the hardware that was supplied with your winch.
4. Assemble the winch and mount assembly to the bumper with the supplied 5/16″ hardware as shown in Figure 2 and 3. At the same time feed you cable through the Roller or Hawse Fairlead.
Figure 3
1
5. Reassemble the bumper to your ATV.
6. using the instructions provided with your winch, wire accordingly.
2.4 2.3
2.2
©2023 Copyright Kappers Fabricating, Inc. All rights reserved
06/09/23
