ITC 69D25X-XX Rana Task Light
PARTS/TOOLS NEEDED
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
- Disconnect power before installing, adding or changing any component.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Use only with UL approved power supply.
Wood Overhead Installation
Clean the mounting surface with a 50/50 mixture of alcohol and water prior to installation. For more detailed instructions please refer to the 3M website*.
The light will come with the mounting plates already attached to the light, simply remove the tape backing and press in place. For added security, remove light from metal mounting plate and screw mounting plate to overhead.
Metal Overhead Installation:
If installing on a metal overhead, first determine installation location and simply attach the light to the overhead using the magnet end. 
Clamp Mount Installation:
Turn the knob counter-clockwise (left) to loosen the clamp. Place clamp in desired location and turn knob clockwise (right) to tighten on to desk. 
*http://www.3m.com/3M/en_US/bonding-and-assembly-us/resources/full-story/?story-id=b3996cbd-9954-455f-8e72-88e452ca38c0
Plug the connector on the power supply cord into the connector attached to the light. 
To install the wire management clips slide the cord into the clip and turn 90° to ensure the cord will stay in place. Then determine installation location and install by removing the paper backing and pressing in place.
The switch is at the end of the lamp. Press to turn light on. To use the dimming function, press and hold the switch in. It will dim to its lowest cycle and then start to brighten again. Re- lease the switch when the light intensity is at the desired level. 
For warranty information please visit www.itc-us.com/warranty-return-policy DOC #: 710-00034 • Rev A • 10/18/18
Full Story
ITC Warranty & Return Policy
