6WS 6300R, 6300V Series Exit Device
Product Information
The 6WS Installation Instruction is a guide for installing the
PDQ 6300R / 6300V Series Exit Device with trim onto a door. The
device comes in two variants, LH/LHR and RH/RHR, depending on the
door’s swing direction. The installation process includes preparing
the trim for installation, installing the trim and exit device,
installing the control board assembly, installing the battery pack,
and installing the batteries and battery cover.
Product Usage Instructions
- Prepare Trim for Installation:
- Refer to the included template and prepare the door
accordingly. - Install the escutcheon trim onto the door while feeding the
wire through the door.
- Install the exit device and secure it with four included pan
head screws. - For Rim Device: Install chassis/head cover. For SVR Device:
Skip to step 4.
- Refer to the included template and install the control board
assembly.
- Install the rod spacer block and control board assembly.
- Plug battery wire into control board.
- Install battery pack over two studs on the mounting plate.
- Snap battery pack onto retainers on control board
assembly.
- Install two batteries and the battery cover with two black pan
head screws.
6WS INSTALLATION INSTRUCTION
FOR PDQ 6300R / 6300V SERIES EXIT DEVICE
1. PREPARE TRIM FOR INSTALLATION
For Mechanical Concerns: Phone: 866-874-3662 www.pdqlocks.com
LH/LHR
RH/RHR
· Rotate lever to proper orientation for door, install square drive spindle into back of trim.
2. INSTALL TRIM AND EXIT
DEVICE
Prepare door according to included template.
Install escutcheon trim onto door while feeding wire through door.
Install exit device and secure with (4) included pan head screws.
Rim Device: Install chassis/head cover. SVR Device: Skip to step 4
MOTOR WIRE
WIRE SLOT
3. RIM DEVICE – INSTALL CONTROL BOARD
· Install control board assembly feed wire through slot under circuit board.
· Secure assembly with (4) included wood/ metal screws.
· Make wire connection after control board is installed. Push extra wire into door cavity.
Rev0 5-26-23
6WS INSTALLATION INSTRUCTION
FOR PDQ 6300R / 6300V SERIES EXIT DEVICE
4. SVR DEVICE – INSTALL SPACER & CONTROL BOARD
· Install rod spacer block with (2) included wood/metal screws feed wires through slot in block.
· Install top rod before control board. · Install control board assembly feed wire
through slot under circuit board and secure assembly with (4) wood/metal screws. · Make wire connections after control board installed. Push extra wire into door cavity. · Install Chassis/Head cover
BATTERY RETAINERS
BATTERY PLUG
TOP ROD
ROD SPACER BLOCK
CONTROL BOARD ASSEMBLY
WIRE SLOT
5. INSTALL BATTERY PACK
Plug battery wire into control board. Install battery pack over two studs on
mounting plate and snap battery pack onto retainers on control board assembly.
BATTERY PACK
6. INSTALL BATTERIES AND BATTERY COVER
Install batteries and battery cover with (2) black pan head screws.
BATTERY COVER
Rev0 5-26-23
Home Page | PDQ
