KW 2521 Pertica 9 Inch Sconce
Product Information
Product Name: Pertica 9 Sconce
Item Number: KW 2521
Model Number: OJ-602B-2P
Country of Origin: United States
Manufacturer: Unknown
Product Description: The Pertica 9 Sconce is a light
fixture designed for wall mounting. It requires proper installation
in accordance with local installation codes and by someone familiar
with its construction and operation. The fixture should be
inspected for any damage or defects before installation.
Product Usage Instructions
- Carefully remove all parts from the box and place them on a
clean, soft surface. - Using the provided screwdriver, remove the screws to detach the
mounting plate (C) from the fixture (H). - Identify the input neutral wire (usually white) from the supply
and connect it to the driver (J) input neutral wire (white) using
the wire nut (A). - Identify the input hot wire (usually black) from the supply and
connect it to the driver (J) input hot wire (black). - Clean the fixture using only a soft dry cloth or feather
duster. Do not use abrasive or chemical agents.
Tools Required (Not Included)
- Phillips Screwdriver
- Slotted Screwdriver
Important Notice
This light fixture should be installed in accordance with all
applicable, local installation codes, and by a person familiar with
the construction and operation of it, as well as the hazards
involved. Inspect the item and its contents carefully. If any
damage or defect is found, do not proceed with the installation.
Retain all packaging material until installation is complete and
approved.
ASSEMBLY INSTRUCTIONS
I H G F
A
+
OJ-602B-2P
c US
J
K1 K2
E
C
Diagram 1
Pertica 9″ Sconce
Item # KW 2521
NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver
Slotted Screwdriver
1. Carefully remove all parts from the box. Place on a clean, soft surface. 2. Remove mounting plate (C) from fixture (H) by removing screws (G)
using provided screwdriver (F). 5. Connect driver (J) input neutral wire (white) to the supply neutral wire
(usually white) using wire nut (A). 6. Connect driver (J) input hot wire (black) to the supply hot wire (usually
black) using wire nut (A). CAUTION: Do not reverse the hot and neutral connections. 7. Insert driver (J) into junction box. 8. Wrap supply ground wire (usually green or bare copper) around the green grounding screw (see diagram 1). Tighten. NOTE: It is imperative that the fixture is grounded. 9. Install mounting plate (C) to the junction box and secure with mounting screws (E). 10. Connect quick connectors (K1) & (K2) together. 11. Install fixture (H) to mounting plate (C) and secure with screws (G) using the provided screwdriver (F). 12. Thread shade (I) to fixture (H). NOTE: Do not over-tighten otherwise glass shade could be damaged.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
M
LI ST ED
US
