HUS4-HF 8 Anchor Screw
Product Information
Product Name: HUS4-H(F) 8
Model: 8 x [L]
Dimensions: df 12mm, 10mm
Thread Size: SW 13
Max Torque: tfix.max1, tfix.max2, tfix.max3
Nominal Embedment Depth: hnom1, hnom2, hnom3
Overall Length: L hnom
Optional Accessories: PS 50, PS 300
Product Usage Instructions
- Choose the appropriate HUS4-H(F) 8 model based on the desired
length (L). - Ensure the diameter of the hole (df) is either 12mm or
10mm. - Insert the anchor into the hole, making sure it is fully
embedded. - Tighten the anchor using the specified torque values:
tfix.max1, tfix.max2, tfix.max3. - Verify that the nominal embedment depth (hnom) matches the
requirements for your application. - Measure the overall length (L hnom) to ensure proper
installation. - If desired, use optional accessories such as PS 50 or PS 300
for enhanced performance. - Refer to the Hilti TD manual for additional guidance on
installation and usage.
Note: The dimensions and thread size may vary depending on the
specific model of HUS4-H(F) 8.
HUS4-H(F) 8
A
tfix.max1
HUS4-H(F) 8x[L] tfix.max1 / tfix.max2 / tfix.max3 HUS4-H(F)
8 x [L]
tfix.max2
tfix.max3
df 12 mm 10 mm
hnom1
hnom2
hnom3
L hnom
SW 13
1
tfix.max
tfix
hnom h1
d0 h2
L tfix.max hnom.req
2310560-06.2022
d0 [mm] 8 8 8 8 6
hnom1 hnom2 hnom3 hnom2 hnom2
40 mm 60 mm 70 mm 60 mm 60 mm
2×
h2
10 mm
3× 25 mm
10 mm
2a
3a
4a
2×
h1
2b
3b
4b
3×
h1
5
6
optional:
7
max. 10 mm 8
max. 2×
SIW 6AT-A22 ½” SIW 4AT-22 ½”
1
SIW 6-22 ½”
SIW 22T-A ½” SIW 22T-A ¾”
SIW 9-A22 ¾”
SIW 8-22 ½”
HUS4-H(F) 8
B B1
B2
B3a
DIBt – ABG
B3b
C C3
C1
Hilti TD
30 mm
C4
HRG 10 HRG 14 HRG 8
HRG 10 HRG 8
B4a
HRG 10 HRG 14 HRG 8
HRG 10 HRG 14 HRG 8
B4b
A
HUS4-H(F) 8
BC2
d0 = 8 mm
e.g. PS 50, PS 300
50 mm 50 mm
50 mm 50 mm
