Solar Lighting Direct Sldihn1-blk-ww Flush Mount Led House Number Instructions

INSTRUCTION GUIDE
Residential Illuminated
House Number
Model No. SLDIHN1-BLK-WW, SLDIHN1-SS-CW, SLDIHN1-SS-WW

PACKAGE CONTENTS

1. 1 x Light Fitting
2. 1 x Pack of Mounting Screws

FEATURES

1. Built in Photo Electric cell
2. 8-10 hours Operation per day
3. Flush Wall Mount base
4. 3 x Numerical sets 0-9 of Vinyl Stickers
5. 1 x Alphabet set of A-F Vinyl Stickers
6. Glass Lens
7. SS – Stainless Steel Finish – Cool or Warm White LED’s
8. BLK – Black P.C. Finish – Warm White LED’s

INSTALLATION METHOD

1. Remove contents from packaging
2. Locate the “ON/OFF” switch and turn light on by setting the ( I,O ) switch on the side of your fitting to ( I ) (FIGURE 1)
3. Locate desired wall mount installation (ensure the location will receive maximum direct sunlight throughout the day)
   Step 1. Stick adhesive house numbers/letters on the front glass surface
   Step 2. Drill 2 holes of 8mm diameter in the wall 154mm apart from one another (FIGURE 1)
   Step 3. Put 2 plastic anchors in the holes and 2 screws into these anchors leaving the head protruding 10mm from the wall
   Step 4. Mount fitting by hooking it onto the screws (making sure it is stable)

IMPORTANT NOTES

• Please ensure you place the solar panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT
• Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified
• It’s best not to install these lights underneath a street light, porch light etc. because this may stop the automatic daynight sensor triggering and result in your lights not turning on

TROUBLESHOOTING

Customer Service Number: 1300 135 911
www.solarlightingdirect.com.au

References

• Solar Lighting Direct - Australia's Premium Solar Powered LED Lighting