8608901-12 Tybee Outdoor Wall Lantern Sconce
Installation Instructions for Tybee Wall Outdoor
General Product Information:
The Tybee Wall Outdoor fixtures are intended to be installed
utilizing NEC compliant junction boxes. This product is safety
listed for wet locations.
CAUTION – RISK OF FIRE: This product must be installed in
accordance with the applicable installation code by a person
familiar with the construction and operation of the product and the
hazards involved. SAVE THESE INSTRUCTIONS!
7400 Linder Ave., Skokie, IL 60077 T 847.410.4400 | F
847.410.4500 www.generationlighting.com
Product Usage Instructions:
- Secure the mounting plate to the junction box.
- Connect the fixture to a suitable ground in accordance to local
electrical codes. - Connect the white fixture wire (square and/or rigid) to the
neutral power line wire with a wire nut. - Connect the black fixture wire (round and/or smooth) to the hot
power line wire with a wire nut. - Neatly place all the wires into the junction box, place the
fixture base onto the mounting studs and secure it in place with
the cap nuts. - Screw the lamp into the socket. Refer to the label on the
socket for Max Wattage Information. - Install the shade to the fixture and secure it in place using
the shade screws. - Caulk around the base of the fixture with waterproof
construction sealant.
Installation Instructions for
Tybee Wall
OUTDOOR
TYBEE_OD_WALL
8508901, 8608901, 8708901, 8808901 1.0
GENERAL PRODUCT INFORMATION:
These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for wet locations. This instruction shows a typical installation.
CAUTION – RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
SAVE THESE INSTRUCTIONS!
©2023 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.
7400 Linder Ave., Skokie, IL 60077 T 847.410.4400 | F 847.410.4500
www.generationlighting.com
Install the Fixture
1A
JUNCTION BOX
MOUNTING PLATE
3 3
2
4
MOUNTING STUD
CAP NUT 5
6
7 SHADE SCREW
SOCKET
LAMP
SHADE 7 8
1 Secure the mounting plate to the junction box. 2 Connect the fixture to a suitable ground in accordance to local electrical codes. 3 Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut. 4 Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut. 5 Neatly place all the wires into the junction box, place the fixture base onto the mounting studs and secure it in place with the
cap nuts. 6 Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information. 7 Install the shade to the fixture and secure it in place using the shade screws. 8 Caulk around the base of the fixture with waterproof construction sealant.
2
Generation Lighting - Our Collections
