SSL-15763 1-Light 12 in.Black Cylinder Outdoor Wall Light Modern Metal Stream Sconce

Product Information: Light Fixture

The light fixture comes with all the necessary hardware for
assembly and installation. The product package includes a fixture,
mounting unit, rubber rings, ball nuts, mounting screws, wire nuts,
and wire strippers. Please note that the parts shown in the manual
may differ slightly per light fixture.

For installation, you will need a ladder, safety glasses,
electrical Phillips screwdriver, flat blade screwdriver, pliers,
and electrical tape. Additionally, you may need to remove the fuse
at the fuse box before starting the installation.

Assembly Instructions

Step 1: Mounting Unit Installation

1. Unscrew the rubber rings and ball nuts from the mounting
   unit.
2. Use the mounting screws to attach the mounting unit to the
   junction box (not included).
3. Attach the fixture to the mounting unit through screw holes as
   shown and secure it with rubber rings and ball nuts.

Step 2: Electrical Connection

Make the electrical connection from the junction box to the
fixture using the following wires:

• Black or Red wire (hot) from the junction box
• White wire (neutral) from the junction box
• Bare or Green ground wire from the junction box

Connect the ground wire to the mounting unit using the
preinstalled green ground screw. Then, connect the positive,
negative, and ground wires with the supplied wire nuts. Secure with
electrical tape.

Step 3: Sealing

Please use caulk in the backplate and wall mounting surface to
prevent water from entering.

Note: Sealing tape is not included in the product package.

Caution

Please use caution when assembling and installing the light
fixture. Make sure to follow the instructions carefully and use the
required tools. Always wear safety glasses when working with
electrical components. Additionally, if necessary, remove the fuse
at the fuse box before starting the installation.

ASSEMBLY INSTRUCTIONS

CAUTION

³Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.

TOOLS REQUIRED

³Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box.

Ladder

Safety glasses

Electrical Phillips

tape

screwdriver

Flat blade screwdriver

Pliers

Wire strippers

HARDWARE INCLUDED

Fixture

Mounting Unit

Rubber Rings Ball Nuts Mounting Screws Wire Nuts

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

EXPLODED PARTS

Wire Nuts

INSTALLATION STEP 1
Unscrew the rubber rings and ball nuts from the mounting unit. Use the mounting screws to attach the mounting unit to the junction box(not included).

Mounting Unit Mounting Screws

Fixture

Rubber Rings Ball Nuts

STEP 2
Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.

STEP 3
Attach the fixture to the mounting unit through screw holes as show,and secure it with rubber rings and ball nuts.
NOTICE: Please use caulk in the back plate and wall mounting surface to prevent water from entering.

Black or Red wire (hot) from the junction box
White wire (neutral) from the junction box
Bare or Green ground wire from the junction box
*Sealing tape (not included)

Black wire from the fixture
White wire from the fixture
Ground wire from the Fixture
*Green Ground Screw