SSL-12171 1-Light Matte Black Outdoor Lantern
Product Information
This product is a light fixture that requires assembly and
installation. It comes with a mounting unit, rubber rings, ball
nuts, mounting screws, wire nuts, and the fixture itself. The
product also requires additional tools for assembly and
installation, including a ladder, safety glasses, an electrical
Phillips screwdriver, a flat blade screwdriver, pliers, wire
strippers, and electrical tape. A junction box is not included but
is necessary for installation.
Product Usage Instructions
- Before starting the assembly process, make sure to remove the
fuse at the fuse box. - Step 1: Unscrew the rubber rings and ball nuts
from the mounting unit. Use the mounting screws to attach the
mounting unit and ball nuts to the junction box (not
included). - Step 2: Make the electrical connection from
the junction box (not included) to the fixture. Connect the ground
wire to the mounting unit using the preinstalled green ground
screw. Next, connect the positive, negative, and ground wires with
the supplied wire nuts. Secure with electrical tape. - Step 3: Attach the fixture to the mounting
unit through screw holes as shown and secure it with rubber rings
and ball nuts. Use caulk in the back plate and wall mounting
surface to prevent water from entering. - Step 4: Install a bulb (not included).
Note: The parts shown in the manual may differ slightly per
light fixture.
ASSEMBLY INSTRUCTIONS
CAUTION
³Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
TOOLS REQUIRED
³Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box.
Ladder
Safety glasses
Electrical Phillips
tape
screwdriver
Flat blade screwdriver
Pliers
Wire strippers
HARDWARE INCLUDED
Fixture
Mounting Unit Rubber Rings Ball Nuts Mounting Screws Wire Nuts
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS
Junction Box (not included)
INSTALLATION
STEP 1
Unscrew the rubber rings and ball nuts from the mounting unit. Rubber Rings Use the mounting screws to attach the mounting unit
Ball Nuts to the junction box (not included).
Wire Nuts Mounting Unit Mounting Screws
Fixture
Bulbs (not included)
STEP 2
Make the electrical connection from the junction (not included) box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Next, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.
Black or Red wire (hot) from the junction box
White wire (neutral) from the junction box
Bare or Green ground wire from the junction box
*Sealing tape (not included)
Black wire from the fixture
White wire from the fixture
Ground wire from the Fixture
*Green Ground Screw
ASSEMBLY INSTRUCTIONS INSTALLATION
STEP 3
Attach the fixture to the mounting unit through screw holes as show,and secure it with rubber rings and ball nuts.
NOTICE: Please use caulk in the back plate and wall mounting surface to prevent water from entering.
*junction box (not included)
STEP 4
Install bulb (not included)
