F88702-11I Outdoor Wall Light

Product Information: Light Fixture

The light fixture is a lighting product that requires assembly
and installation. It includes a mounting unit, fixture, ball nuts,
rubber rings, mounting screws, wire nuts, and hardware for
installation. The product requires tools such as a ladder, safety
glasses, electrical Phillips screwdriver, flat blade screwdriver,
pliers, and wire strippers for assembly and installation.

Assembly Instructions

Before assembling or installing the light fixture, ensure that
the fuse at the fuse box is removed. Follow the below instructions
to assemble the light fixture:

Step 1: Attach Mounting Unit

1. Unscrew the ball nuts from the mounting unit.
2. Use the mounting screws to attach the mounting unit to the
   junction box.

Step 2: Make Electrical Connection

1. Connect the ground wire to the mounting unit using the
   preinstalled green ground screw.
2. Connect the positive, negative, and ground wires from the
   junction box to the fixture using the supplied wire nuts.
3. Secure with electrical tape.

Step 3: Attach Fixture

1. Attach the fixture to the mounting unit through screw holes as
   shown.
2. Secure it with rubber rings and ball nuts.
3. Apply caulk in the backplate and wall mounting surface to
   prevent water from entering.

Step 4: Install Bulb

Install a bulb (not included) in the fixture.

Note: The parts shown in the manual may differ slightly per
light fixture.

By following these instructions, you can assemble and install
the light fixture and enjoy its benefits.

ASSEMBLY INSTRUCTIONS

CAUTION

³Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.

TOOLS REQUIRED

³Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box.

Ladder

Safety glasses

Electrical Phillips

tape

screwdriver

Flat blade screwdriver

Pliers

Wire strippers

HARDWARE INCLUDED

Fixture

Mounting Unit

Ball Nuts

Rubber Rings Mounting Screws Wire Nuts

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

EXPLODED PARTS
Wire Nuts

Rubber ring Ball Nuts

INSTALLATION
STEP 1
Unscrew the ball nuts from the mounting unit. Use the mounting screws to attach the mounting unit to the junction box.

Mounting Unit Mounting Screws

Fixture

Bulbs (not included)
STEP 2
Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.

Black or Red wire (hot) from the junction box
White wire (neutral) from the junction box
Bare or Green ground wire from the junction box
*Sealing tape (not included)

Black wire from the fixture
White wire from the fixture
Ground wire from the Fixture
*Green Ground Screw

ASSEMBLY INSTRUCTIONS INSTALLATION

STEP 3
Attach the fixture to the mounting unit through screw holes as shown, and secure it with rubber rings and ball nuts.
NOTICE: Please use caulk in the back plate and wall mounting surface to prevent water from entering.
STEP 4
Install bulb (not included)