TRIC A HDC On Roof Module Mounting System
Product Information: Wagner Solar Aufdach-Modulmontagesystem
TRIC A HDC
The Wagner Solar Aufdach-Modulmontagesystem TRIC A HDC is a
mounting system for solar modules that can be installed on roofs.
The system is designed to be project-specific and must be installed
according to structural engineering standards and regulations (EN
19911-3 and -1-4). A solid mounting base that can accommodate the
occurring forces (weight, wind and snow loads) is required for
proper application. The installation instructions of the solar
module manufacturers must be adhered to.
Product Usage: Installation Instructions
Before installation, make sure to read and understand all
instructions carefully. The following steps should be followed for
proper installation of the Wagner Solar Aufdach-Modulmontagesystem
TRIC A HDC:
Step 1: Mounting the Panel Rails
Install the panel rails according to the specified structural
engineering standards and regulations. Tighten the screws to a
torque of 17 Nm for S13 and 30 Nm for S15. The maximum distance
between the rails should be 18000 mm and the maximum distance
between the roof brackets should be 450 mm.
Step 2: Cross Bonding (only when required)
If necessary, install the cross bonding by tightening the screws
to a torque of 30 Nm for S15.
Step 3: Module Installation
Install the solar modules according to the installation
instructions provided by the manufacturer. Use a torque of 10 Nm
for S5 screws and 30 Nm for S15 screws. The minimum distance
between the modules should be 5 mm. Use the TRIC clip to connect
the modules securely.
Wagner Solar
DE MONTAGEANLEITUNG
Aufdach-Modulmontagesystem TRIC A HDC
EN INSTALLATION INSTRUCTIONS
On Roof Module Mounting System TRIC A HDC
FR INSTRUCTIONS DE MONTAGE
Système de montage de modules sur toiture TRIC A HDC
XX-INT_TRIC-A-HDC-TRIC-clip_MA-230118-1WA20348
1
DE Wichtige Hinweise
Montage / Mounting
Die Auslegung des Montagesystems (Dachankerzahl,
Schienentragweite etc.) ist projektbezogen entspre-
chend den vorgegeben Normen (DIN EN 1991-1-3
und DIN EN 1991-1-4:2010-12, Einwirkung auf Trag-
werke Allgemeine Einwirkungen – Schneelasten und
Windlasten) durchzuführen.
Voraussetzung für den bestimmungsgemäßen Einsatz
ist immer ein geeigneter Befestigungsuntergrund, der
die auftretenden Kräfte (Gewichtslast, Wind und
Schneelast) aufnehmen kann.
Die Montagevorschriften der Solarmodulhersteller
sind einzuhalten.
S 13 S 15
S 5
EN Important Notes
The dimensioning of the mounting system (number of roof brackets etc.) should be specifically carried out for each individual project, following the specified structural engineering standards and regulations (EN 19911-3 and -1-4).
Prerequisite for the proper application always is a solid mounting base that can accommodate the occurring forces (weight, wind and snow loads).
The installation instructions of the solar module manufacturers must be adhered to.
Alle Maße in mm
mm
All dimensions in mm
Toutes les dimensions sont en mm
FR Notice importante
Le dimensionnement du système de fixation (nombre des pattes de fixation, distance entre deux pattes etc.) doit être calculé en fonction des donnés du projet et devra satisfaire aux normes spécifiés (EN 1991-1-3 et -1-4).
Une structure de base appropriée pouvant résister aux efforts en présence (poids, vent et neige) représente la condition préalable au respect des normes.
Respectez les instructions de montage du constructeur des modules solaires.
2
XX-INT_TRIC-A-HDC-TRIC-clip_MA-230118-1WA20348
Modulmontageschienen montieren / Installing the panel rails / Montage des rails de support des modules
S 13 17 Nm
1/2 1/2
30 max. 18000
max. 18000
max. 450
in. 900 m
MANUAL
XX-INT_TRIC-A-HDC-TRIC-clip_MA-230118-1WA20348
S15 30 Nm
3
Kreuzverbund (nur bei Bedarf) / Cross Bonding (only when required) / Montage en croix (uniquement en cas de besoin)
S15 30 Nm
4
XX-INT_TRIC-A-HDC-TRIC-clip_MA-230118-1WA20348
Modulmontage / Module installation / Montage des modules
MANUAL
Click!
min 5
S 5 10 Nm
XX-INT_TRIC-A-HDC-TRIC-clip_MA-230118-1WA20348
1 Click!
2
5
min. 5
6
XX-INT_TRIC-A-HDC-TRIC-clip_MA-230118-1WA20348
Potenzialausgleich / Equipotential Bonding / Équilibre de potentiel
S15 30 Nm
XX-INT_TRIC-A-HDC-TRIC-clip_MA-230118-1WA20348
7
Irrtum und Änderungen vorbehalten · © Wagner Solar GmbH, 2023 · www.wagner-solar.com
8
Wagner Solar GmbH · Sonnenallee 2 · D-35274 Kichhain +49 (0)6421 80 07-0
Mit Solarenergie in eine saubere Zukunft - Systemanbieter für Photovoltaik, Solarthermie und Montagesysteme | Wagner Solar
