F78152-QC 2 Light 14 Inch Modern Style Semi Flush Mount
Product Information
The product is a light fixture that comes with all the necessary
hardware for installation. The hardware includes the fixture, glass
shade, threaded pipe and hex nut, washer, rubber ring, cap, ball
nuts, mounting screws, and mounting unit wire nuts. The product
requires assembly and the user must have a ladder, safety glasses,
electrical Phillips screwdriver, flat blade screwdriver, pliers,
and wire strippers. The product is designed for indoor use
only.
Product Usage Instructions
- Use the mounting screws to attach the mounting unit to the
junction box. - Make the electrical connection from the junction box to the
fixture. Connect the ground wire to the mounting unit using the
preinstalled green ground screw. Then, connect the positive,
negative and ground wires with the supplied wire nuts. Secure with
electrical tape.
- The black or red wire (hot) from the junction box should be
connected to the black wire from the fixture. - The white wire (neutral) from the junction box should be
connected to the white wire from the fixture. - The bare or green ground wire from the junction box should be
connected to the ground wire from the fixture.
fixture screws and rotating the fixture until it locks in place.
Then tighten the fixture screws securely.
secure it with hex nut.
threaded pipe and hex nut, then secure with ball nut.
Caution: Before starting any installation, make
sure to turn off the power supply by removing the fuse at the fuse
box. Always wear safety glasses when installing the product. If you
are unsure about any part of the installation process, consult a
licensed electrician.
ASSEMBLY INSTRUCTIONS
CAUTION
³Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
TOOLS REQUIRED
³Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box.
Ladder
Safety glasses
Electrical Phillips
tape
screwdriver
Flat blade screwdriver
Pliers
Wire strippers
HARDWARE INCLUDED
Fixture
Glass Shade
Threaded Pipe and Hex Nut
Washer
Rubber Ring
Cap
Ball Nuts
Mounting Screws
Mounting Unit Wire Nuts
EXPLODED PARTS
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE INSTALLATION
Wire Nuts
Mounting Unit
STEP 1
Use the mounting screws to attach the mounting unit to the junction box.
Bulbs (not included)
Glass Shade
Mounting Screws
Fixture
STEP 2
Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape.
Threaded Pipe and Hex Nut
Washer
Black or Red wire (hot) from the junction box
White wire (neutral) from the junction box
Bare or Green ground wire from the junction box
*Sealing tape (not included)
Black wire from the fixture
White wire from the fixture
Ground wire from the Fixture
*Green Ground Screw
Rubber Ring
Cap Ball Nuts
ASSEMBLY INSTRUCTIONS INSTALLATION
STEP 3
Attach the fixture to the mounting unit by inserting two fixture screws and rotating the fixture until it locks in place. Then tighten the fixture screws securely.
STEP 4
Screw the threaded pipe and hex nut into the
fixture, then secure it with hex nut.
STEP 5
Install bulb (not included)
STEP 6
Place the washer, rubber ring, glass shade and cap onto the threaded pipe and hex nut, then secure with ball nut.
