Qnap Qhora-301w Next Generation Wifi 6 Dual Port 10gbe Sd-wan Router Installation Guide

Qnap Qhora-301w Next Generation Wifi 6 Dual Port 10gbe Sd-wan Router Installation Guide

QNAP logoQHora-301W
QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN RouterQuick Installation Guide
www.qnap.com

QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - fig1QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - fig2

LED Behavior

LED

Status

Description

1. PowerGreenThe device is ready.
2. StatusRedA system error occurred while powering on the device.
Flashes green
  • The firmware is updating.
  • The device is restarting.
  • The device is being initialized.
  • The device is locating another device.
GreenThe device is ready.
3.1 Gigabit Ethernet PortGreenPort link established
AmberWAN port link established
4. 10 Gigabit Ethernet PortGreenPort link established
AmberWAN port link established
5.  Wi-FiGreenWi-Fi link established
Flashes greenPress the WPS button for 3 seconds
QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - fig3QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - fig4

Audio Alert

DurationFrequency

Description

Long and short beeps1 long and 2 short beepsThe router is resetting configurations and rebooting (reset button).
2 long beeps and 1 short beepThe router has completed the firmware update.
Long beep1The router is starting up.
Short beep10 (every 1 minute)The CPU is overheating.
  • Verify if the router is adequately ventilated and is placed in an open space. (Do not stack the router.)
  • The alert stops once the temperature is below the threshold limit.

QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - icon1QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - icon2Download Center
www.qnap.com/download

Visit Download Center for our full guides and utilities.

FCC Compliance Statement

QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - icon3This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and complies with the Class B digital device limits, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference cannot occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by taking one of the following actions:

  1. Reorient or relocate the receiving antenna.
  2. Increase the separation between the equipment and the receiver.
  3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  4. Consult the dealer or an experienced radio/TV technician for help.

FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. RF Modules installed
in this product must not be co-located or operating in conjunction with any other antenna or transmitters, except when installed in accordance with FCC multi-transmitter product guidelines.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for uncontrolled environments. This equipment must be installed and operated with a minimum distance of 27cm between the radiator/antennas and the general public
This device complies with CE compliance Class B.
CE Marking
QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - icon4The equipment described in this document faithfully complies with: European Union Radio Equipment Directive (RED) 2014/53/EU. The Declaration of Conformity is provided to customers with other technical documents upon request and is accessible from https://www.qnap.com/en/contact-us/ to authorized users. Radiation exposure statement This equipment complies with radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 27 cm between the radiator and your body. For operation within the 5.15 ~ 5.35GHz frequency range, it is restricted to the indoor environment.
Hereby, QNAP Systems, Inc. declares that the radio equipment type QHora-301W is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: www.qnap.com 
Data transmission is handled by software. Via software, it can define the rule. When the equipment has no data to transmit, only the control frame will be sent (like 802.11
management frame, such as beacon and probe Response). When failing to operate, it will stop the service automatically
ISED Compliance Statement
Note: Industry Canada has been renamed Innovation, Science, and Economic Development Canada (ISED) following the issue of RSP-100 Issue 11 and DC-01 Issue 06. Equipment certifications previously issued by Industry Canada remain valid and do not require updating. Meaning you may see the names used interchangeably in the documentation. The following statement is applicable to ASiR-pRRH which has Innovation, Science and Economic Development (ISED) approval: This device complies with ICES-003 of Industry Canada’s license-exempt RSS. Operation is subject to the following two conditions

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Radiation Exposure Statement
This product complies with IC radiation exposure limits set forth for an uncontrolled environment. To comply with RSS 102 RF exposure compliance requirements, a separation distance of at least 27 cm must be maintained between the antenna of this device and all persons.
The device for the band 5150-5350 MHz is only for indoor usage to reduce the potential for harmful interference to co-channel mobile satellite systems.
QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - icon5According to the requirement of the WEEE legislation, the following user information is provided to customers for all branded QNAP Electronics products subject to the WEEE directive.
This symbol on the product or on its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste equipment for recycling, please contact your local city office, your household waste disposal service, or the shop where you purchased the product.
RED 2014/53/EU Article 10 Compliance
RED 2014/53/EU requires that for products that could potentially have an issue with a non-harmonized frequency in a specific EU country, the product documentation must list the restrictions, and the packaging must carry a label reflecting that country’s code.

QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - icon6

AT

BEBGHRCYCZDK

EE

FlFRDEELHU

IE

ITLVLTLUMTNL

PL

PTROSKSIESSE

UK

EU RoHS statement
This equipment complies with the European Union RoHS Directive 2011/65/EU on the restriction of the use of certain hazardous substances in electrical and electronic equipment.
The directive applies to the use of lead, mercury, cadmium, hexavalent chromium, polybrominated biphenyls (PBB), and polybrominated diphenyl ethers (PBDE) in electrical
and electronic equipment.

QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - fig40

QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - icon11www.qnap.com
QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - icon12helpdesk.qnap.com
QNAP QHora-301W Next Generation WiFi 6 Dual Port 10GbE SD-WAN Router - icon14docs.qnap.com

QNAP logoPrinted in China
P/N: 51000-024870-RS

References

Documents / Resouces

Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.


Related Manuals