- Turn diverter knob on side to correct setting for vacuum or hose
- Press the dirt tank release button and pull dirt tank off machine
- Holding the tank over a trash bin, press the Release Button on back to empty
- Twist the top to the right to open tank
- Remove Pre-Motor Filter and clean with water and mild detergent
- Allow to completely dry before reinstalling
- Filter should be installed with fabric tab (text side) facing up
- Cyclone system under filter can be broken down into 3 parts by twisting each part to the right
- All pieces can be washed
- Allow to completely dry before reinstalling
- Line cyclone system up with dirt container by using the semi circular and square tabs, then slide in
- Twist dirt cup back together until the arrow with the lock symbol on tank matches arrow on top of tank
- Remove hose from machine by pinching clips on bottom of hose and pressing “release” button on handle
- Run a broom handle through hose to remove any clogs
- If hose is damaged, it will need to be replaced
- Turn machine over and use a coin or flathead screwdriver to open the 2 locking screws on either side of the brush bar and remove both brush plates
- Grasp brush from bottom and pull out to remove
- Clean brush of any debris before reassembling
- If brush is damaged or does not spin freely by hand, it will need to be replaced
- If the vacuum still does not have suction, Contact Us
