the serviced apartment company
Operating Instructions – Dishwasher Neff SL15J1F
Control Panel
| 1 – Main Switch 2 – Door Handle 3 – Programme END indicator | 4 – Low salt indicator 5 – Low rinse aid indicator 6 – Programme buttons |
Appliance Interior
| 20 – Top basket 21 – Additional cutlery basket 22 – Top spray arm 23 – Additional cup rack 24 – Bottom spray arm 25 – Float 26 – Bottom basket | 27 – Dispenser for salt with refill indicator 28 – Filters 29 – Cutlery basket 30 – Dispenser for rinse aid with refill indicator 31 – Detergent dispenser |
- Your dishwasher will be prepared with a rinse aid and dishwasher salt
Programme overview
Switching on the appliance
- Switch on the main switch
. The selection of the most recently selected programme will light up. This programme will be performed unless another programme button 
is pressed - Close the door & the programme will start automatically
. The selection of the most recently selected programme will light up. This programme will be performed unless another programme button 
is pressedEnd of programme
- The programme has come to an end when the PROGRAMME END indicator
and the indicator for the selected programme are both lit up. - The end of the programme is also indicated by a buzzer
and the indicator for the selected programme are both lit up.Switching the dishwasher off
Several minutes after the programme has ended:
- Open the door when the programme has ended
- Set the main switch to OFF
- Remove dishes etc when they have cooled down
Programme interruption
- Carefully open the door, and only open completely when the spray arm is no longer turning. If the programme is already in ‘drying’ mode, a noise will signal to remind you to close the appliance door or to abort the programme
- Switch OFF the main switch
- The indicator light will go out and the programme will remain stored
- In order to continue with the programme, switch the main switch ON again and close the door
Cancel Programme (Reset)
- Only when the master is ON. Press the
and
programme buttons at the same time and hold them down for approximately 3 seconds - The programme continues for approximately 1 minute. The PROGRAMME END indicator for the programme that has just been terminated lights up
- Set the main switch to OFF
and
programme buttons at the same time and hold them down for approximately 3 secondsChanging the programme
- It is possible to change the programme selection after you have switched the dishwasher on, provided that you have not yet closed the door. If it is necessary to change the programme after this, the programme cycle that has already begun will still carry on to the end.
