100W LED High Bay Light
Product Information
The LED High Bay Light is a high-quality lighting solution
designed for various applications such as gas stations, exhibition
halls, factories, highway toll stations, workshops, warehouses,
stadiums, and supermarkets. It features unique high-brightness SMD
chips, high-purity aluminum heat sinks, and high-efficiency
constant current and constant voltage power drivers.
Technical Parameters:
- Available Wattages: 100W, 150W, 200W, 240W, 300W, 400W,
480W
Product Usage Instructions
- Installation Steps:
- Install the O-rings and screw them tight.
- Screw in the M until it is tightened flush.
- Install the Cable/Pendant:
- For Aircraft cable installation:
- Adjust the angle as required.
- Tighten the set screws securely to protect against
loosening.
- Adjust the angle as required.
- Tighten the set screws securely to protect against
loosening.
- Problem: LEDs stop working or flash on and off
- Possible Cause: Power failure, fault with LED driver, damage to
LED chips, abnormal output of the driver, LED chip breakdown,
voltage instability. - Solutions: Check the circuit, replace with a new driver,
replace with a new LED board, replace with a new driver, replace
with a new LED board, power-off and check the power supply.
- Possible Cause: Power failure, fault with LED driver, damage to
Installation Steps
Black White Yellow/Green
Dim+ Dim-
Red Black
Install the O-rings and screw tight. Screw in the M, tightening until flush.
Install the cable/pendant
LED High Bay Light
100W/150W/200W/240W/300W/400W/480W
Adjust the angle as required, then tighten the set screws securely toprotect against loosening
Aircraft cable installation
Pendant installation
Scope of Application
With unique high-brightness SMD chips, high-purity aluminium heats sinks, high-efficiency constant current and constant voltage power drivers, this LED high bay light is designed for high quality lighting for gas stations, exhibition halls, factoried, highway toll stations, workshop, warehouses, stadiums, supermarkets and similar applications, etc.
Technical Parameters
Warning
**mm **mm **mm **mm **mm **mm **mm
Trouble Shooting
Do not disassemble light without authorization. Please report any abnormalities to the manufacturer.
Problem
Possible Cause
The power line/plug is improperly connected.
Solutions
Reconnect the power cable/plug.
LEDs stop working LEDs flash on and off
Power failure. Fault with LED driver. Damage to LED chips. The output of the driver is abnormal. The LED chip breaks down. Voltage instability.
Check the circuit. Replace with new driver. Replace with new LEDs board. Replace with new driver. Replace with new LED board. Power-off and check the power supply.
