My Turboclean/powerforce/powerclean Powerbrush Pet Has No Suction | Support

If you are experiencing No/Low Suction, follow these steps to resolve:

• Turn off and unplug machine
• Remove dirty water tank by pulling out and up on the side latches
  • Lift up on the handle to remove

          

• Open rubber tab on top of dirty water tank, pour out dirty water
  • Rinse tank thoroughly
  • Close rubber tab

               

• Inspect dirty water tank for cracks or damage
  • If damaged, replace dirty water tank > Go to Parts & Supplies 
• Remove debris from red filter

• Plug machine in and turn on
• Put your hand over the red filter to feel for suction
• Is there suction?
  • Yes > Turn off and Unplug machine
  • No > Visit a BISSELL Authorized Service Center or Contact Us
• Remove float stack from dirty water tank unscrewing the ring at the bottom of the tank

• Rinse the float stack under water to remove any debris
  • Ensure that float stack can freely move up and down

• Put float stack back into dirty water tank aligning the arrow on the float with the notch on the tank
  • Twist ring into place to secure float

• Grab the top of nozzle and pull away to remove it

• Rinse nozzle under water and wipe debris from machine where nozzle was

• Replace nozzle aligning the top into channel in front of red filter, use both hands to push bottom portion of nozzle into place

               

• Return dirty water tank to machine, secure with latches

               

• Plug machine in and turn on
• Check for suction by performing a few wet and dry cleaning strokes
  • Has this resolved your issue?
    • Yes > Great! Glad we can get you back to cleaning
    • No > Is there spray?
      • Yes > Visit a BISSELL Authorized Service Center or Contact Us
      • No > Go to Low/No Spray