- Unplug machine
- Empty dirt container by sliding the Lock ‘n Seal Lever to the unlock position
- Pull dirt container straight out of machine
- Take out inner cyclone from upper tank by twisting to the left and pulling down
- The cyclone may be washed with a mild detergent
- Allow to air dry completely (24-48 hours) before replacing in machine
- Remove foam pre-motor filter located in slide out tray below dirt container
- Clean with water and mild detergent
- Allow to air dry completely (24-48 hours) before replacing in machine
- Take out white pleated post-motor filter located beneath foam filter
- Post-motor filter is NOT washable and must be replaced when dirty
- Separate the upholstery hose from where it meets back of machine by twisting to the left and pull out of lower hose
- Run a broom handle through hose to remove any clogs
- If hose is cracked or damaged, a new one will be needed
- Take out 2 screws from left side of lower hose on the back of machine
- Straighten this section of hose and run a broom handle through the lower hose to remove any clogs
- Reinstall screws on lower hose and return upholstery hose to machine
- Upholstery hose should be firmly connected into lower hose
- If machine still does not have suction, visit a BISSELL Authorized Service Center or Contact Us
