Anslut 019951 Led Clamp Spotlight Instruction Manual

Anslut 019951 Led Clamp Spotlight Instruction Manual

anslut -logoDanger icon Item no. 019951, 019953
CLAMP SPOTLIGHT LED

anslut 019951 LED Clamp Spotlight-

OPERATING INSTRUCTIONS

warning 4 Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions)

Care for the environment!
Recycle discarded products in accordance with local regulations.
Jula reserves the right to make changes.
For latest version of operating instructions, see www.jula.com

anslut 019951 LED Clamp Spotlight-fig1

SAFETY INSTRUCTIONS

  • Only intended for indoor use.
  • Do not connect the product to the mains when it is still in the pack.
  • Do not look directly into the light source.
  • Do not store the product in a damp or very cold/hot place, this can damage the electronics.
  • The electronics in the product are sensitive to knocks and blows. Avoid dropping it.
  • No parts of the product can be replaced or repaired. The whole product must be discarded if any part is damaged.
  • The power cord on this product is not replaceable, if damaged discard the complete product.
  • Do not use the product in a bathroom, or in damp or wet areas.
  • The light source is not replaceable. Discard the product if the light source stops working.
  • Switch off the product before cleaning.
  • Do not touch the power cord or the plug with wet hands or wet parts of your body.

SYMBOLS

Danger iconRead the instructions.
indoor use only.Only intended for indoor use.
Double insulationSafety class II.
anslut -iconNon-replaceable light source.
anslut -icon1Non-replaceable actuator.
CE SYMBOLApproved in accordance with the relevant directives.
Dustbin IconRecycle discarded product in accordance with local regulations.

TECHNICAL DATA

Rated voltage230 V ~ 50 Hz
Output4 W
Luminous flux320 lm
Colour temperature3000 K
Diffusion angle80°
Life span30 000 h
Off/On15000 times
Energy classThis product contains a light source with energy efficiency class F.
Safety classII
Protection ratingIP20

INSTALLATION

See figure for installation instructions.
FIG. 1

USE

  1. Plug the plug into the powerpoint.
  2. Press the switch to switch on the light.
  3. Press the switch to switch off the light.

DISMANTLING

  1. Remove the top cover with a screwdriver.
  2. Undo the 2 screws on the sides.
  3. Release the soldered wire by melting the solder with a soldering iron.
  4. Remove the aluminum cover with a screwdriver.
  5. Release the soldered wire by melting the solder with a soldering iron.
  6. Done!

Dustbin Icon
2022-04-04
© Jula AB
JULA AB, BOX 363, SE-532 24 SKARA

References

Documents / Resouces

Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.


Related Manuals