LOLLI LOCKIT Suction Mount Flat-Ring Assembly
Flat-Ring Assembly
- Extend Pop Holder to full extension
- Remove adhesive backing from metal flat-ring
- Place flat-ring over end of Pop Holder while aligning the space cutouts on the flat-ring to widest points of the Pop Holder rim
- Align the flat-ring to the base of the Pop Holder and firmly press into place until securely fastened.
Mount Assembly
- Place the fastener ring over round knob of the mount with narrower end facing mount
- Insert knob on mount into socket of cradle and fasten ring
Mount setup
- Choose a mounting location and ensure that it is clean and dry (For optimal adhesion, mount and surface should be above 60°)
- Release the mounting lever lock by pulling lever away from mount
- Remove protective film from the adhesive on the underside of the mount.
- Position the mount on mounting location and press into place
- Lock the mounting lever by pressing lever towards the mount
Using Lolli Lockit
- Guide your phone‘s Pop Holder toward the center of Lolli Lockit, once close, the magnetic pull will securely connected with your phone holding in place. You may adjust the orientation to your liking.
- To remove, grasp your phone and pull away from base.
Contact us
[email protected]
Warranty information lollilockit.com for details.
