MOUNTAIN OAK-18 Vented Gas Log Set with Remote Control Kit
Product Information
Model: MOUNTAIN OAK-18
Manufacturer: Hearth & Home Technologies
Product Type: Gas Log Set
Log Placement Instructions
WARNING!
The positioning of the logs is critical to the safe, clean
operation of this gas log set. Sooting and other problems may
result if the logs are not properly positioned per these
instructions. Failure to position in accordance with the diagrams
below, or failure to use only parts specifically approved for this
log set may result in property damage or personal injury.
PLACE MOUNTAIN OAK-18 LOGS
- Place Rear Log (#1) on rear support. (Refer to Figure 1)
- Place Middle Log (#2) on middle support. (Refer to Figure
2) - Place Front Log (#3) in between burner and grate. (Refer to
Figure 3) - Rest Top Log (#4) in front and middle log cutouts. (Refer to
Figure 4)
NOTE: Logs #1, #2, and #3 have ridges on the
bottom which secure the logs to the burner frame. After installing
each log, check to be sure it is stable.
Log Placement Diagrams:
WARNING:
DO NOT sprinkle volcanic rock on the logs or around the pilot or
the main burner. This may cause sooting. Only place volcanic rock
on the floor of the fireplace. During the initial operation of the
new heater, burning logs will give off a paper burning smell, and
orange flames will be present. Simply open the windows for a few
hours to vent the odor.
For more information, please visit www.hearthnhome.com
Log Placement Instructions
Models: MOUNTAIN OAK-18
WARNING!
The positioning of the logs is critical to the safe, clean operation of this gas log set. Sooting and other problems may result if the logs are not properly positioned per these instructions. Failure to position in accordance with the diagrams below, or failure to use only parts specifically approved for this log set may result in property damage or personal injury.
Hearth & Home Technologies · Mountain Oak Installation Instructions · 4625-905 Rev. A · 02/23
PLACE MOUNTAIN OAK-18 LOGS
1. Place Rear Log (#1) on rear support. Figure 1
2. Place Middle Log (#2) on middle support. Figure 2
3. Place Front Log (#3) in between burner and grate. Figure 3
4. Rest Top Log (#4) in front and middle log cutouts. Figure 4
NOTE: Logs #1, #2 and #3 have ridges on the bottom which secure the logs to burner frame. After installing each log, check to be sure it is stable.
Rear Log #1
Figure 3 Place Front Log
Top Log #4
Front Log #3
Figure 1 Place Rear Log Middle Log #2
Figure 2 Place Middle Log
WARNING
Figure 4 Place Top Log
PLACE THE DECORATIVE ROCK
DO NOT sprinkle volcanic rock on the logs or around the pilot or the main burner. This may cause sooting. Only place volcanic rock on the floor of the fireplace. During initial operation of the new heater, burning logs will give off a paper burning smell and orange flames will be present. Simply open the windows for a few hours to vent the odor.
Hearth & Home Technologies 7571 215th Street West, Lakeville, MN 50044
www.hearthnhome.com
2
Hearth & Home Technologies · Mountain Oak Installation Instructions · 4625-905 Rev. A · 02/23
hearthnhome.com
