MOUNTAIN OAK-24/30 Gas Log Set Log Placement
Product Information
The product mentioned in the user manual is the MOUNTAIN
OAK-24/30 gas log set. It is important to follow the log placement
instructions provided to ensure safe and clean operation. Failure
to position the logs correctly or use approved parts may result in
property damage or personal injury.
Log Placement Instructions
Follow the steps below to properly place the MOUNTAIN OAK-24/30
log set:
- Place the Rear Log (#1) on the rear support. Refer to Figure 1
for reference. - Place the Middle Log (#2) on the middle support. Refer to
Figure 2 for reference. - Place the Front Log (#3) in between the burner and grate. Refer
to Figure 3 for reference. - Place the Top Right Log (#4) in the bottom log cutouts. Refer
to Figure 4 for reference. - Rest the Top Left Log (#5) in the front and middle log cutouts.
Refer to Figure 4 for reference.
Note: Logs #1, #2, and #3 have ridges on the bottom that secure
them to the burner frame. After installing each log, ensure it is
stable.
Refer to the provided diagrams for visual guidance on log
placement.
Decorative Rock Placement
Do not sprinkle volcanic rock on the logs or around the pilot or
main burner, as this may cause sooting. Only place volcanic rock on
the floor of the fireplace.
During the initial operation of the new heater, burning logs may
emit a paper burning smell and orange flames. To vent the odor,
simply open the windows for a few hours.
For more information about the product, visit the official
website of Hearth & Home Technologies: www.hearthnhome.com
Address: 7571 215th Street West, Lakeville, MN 50044
Log Placement Instructions
Models: MOUNTAIN OAK-24/30
WARNING!
The positioning of the logs is critical to the safe, clean operation of this gas log set. Sooting and other problems may result if the logs are not properly positioned per these instructions. Failure to position in accordance with the diagrams below, or failure to use only parts specifically approved for this log set may result in property damage or personal injury.
Hearth & Home Technologies · Mountain Oak 24/30 Installation Instructions · 4625-906 Rev. A · 02/23
PLACE MOUNTAIN OAK-24/30 LOG SETS
1. Place Rear Log (#1) on rear support. Figure 1 2. Place Middle Log (#2) on middle support. Figure 2 3. Place Front Log (#3) in between burner and grate.
Figure 3 4. Place Top Right Log (#4) in bottom log cutouts. Figure 4 5. Rest Top Left Log (#5) in front and middle log cutouts.
Figure 4
NOTE: Logs #1, #2 and #3 have ridges on the bottom which secure the logs to burner frame. After installing each log, check to be sure it is stable.
Rear Log #1
Figure 3 Place Front Log
Top Left Log #5
Front Log #3
Top Right Log #4
Figure 1 Place Rear Log
MIddle Log #2
Figure 2 Place Middle Log
WARNING
Figure 4 Place Top Right and Left Logs
PLACE THE DECORATIVE ROCK
DO NOT sprinkle volcanic rock on the logs or around the pilot or the main burner. This may cause sooting. Only place volcanic rock on the floor of the fireplace. During initial operation of the new heater, burning logs will give off a paper burning smell and orange flames will be present. Simply open the windows for a few hours to vent the odor.
Hearth & Home Technologies 7571 215th Street West, Lakeville, MN 50044
www.hearthnhome.com
2
Hearth & Home Technologies · Mountain Oak 24/30 Installation Instructions · 4625-906 Rev. A · 02/23
hearthnhome.com
