- Check the bag and replace if full
- Check the pre-motor filters for debris
- One filter is located inside the bag tank in a plastic cage
- Other filter is located under bag tank in round center portion of Lock ‘n Seal Lever
- Both filters and cage can be rinsed in warm water
- Air dry completely before reinstalling in machine
- Check post-motor filter on side of vacuum for debris
- The white post-motor filter is not washable and will need to be replaced when dirty
- With the bag tank removed, turn on machine feel for suction at motor duct where small, round pre-motor filter sits then turn off machine
- If no suction, visit a BISSELL Authorized Service Center or Contact Us
- Upper-tank and dirt/air ramp may need to be wiped clean if dirty
- Clear any debris from suction inlet in upper right corner of upper tank
- Twist hose to the left to remove from back of vacuum and pull out of lower hose
- Push a broom handle through hose to remove clogs
- Hose will need to be replaced if cracked or damaged
- Remove the screw from left side of lower hose on back of machine and straighten hose
- Push a broom handle through hose to remove clogs
- The access plate can also be removed to help clear clogs
- If still no suction, please contact a BISSELL Authorized Service Center or Contact Us
