Dewertokin Technology Group Rf5111 Remote Control Instructions

Technology Group RF5111 Remote
Control Instructions

appearance

Key function

Key-value	Specification
PAIR	press and hold + Dutton,the remote enters pairing mode, backlight LED flashes, When the pair succeeds, the backlight stops flashing then normally on.
HEAD UP	Press and hold button, the head actuator moves out, stop when released
HEAD DOWN	Press and hold  button, the head actuator moves in, stop when released

FOOT UP	Press and hold button, foot actuator moves out, stop when released
FOODTOWN	Press and hold the button. foot actuator moves in. stop when released
FLAT	Click button. the bed goes flat
ZG	Click button. the bed moves to zero position. press and hold the zeroG button for 5s. until backlight flashes, the control set the current position as zeroG position
TV/PC	Click the button, the bed moves to TV/PC position, press and hold TV/PC button for 5s, until backlight flashes, the control set the current position as TV/PC position
Antisnore	Click button. the bed moves to the Antisnorc position. press and hold the Antisnorc button for 5s. until the backlight flashes. the control set the current position as Antisnorc position
MI	Click the button, the bed moves to M I position. press and hold M I button for 5s. until backlight flashes, the control set the current position as MI position
M2	Click the button, the bed moves to M2 position, press and hold M2 button for 5s. until backlight flashes, the control set the current position as M2 position
FLASHLIGHT	Press and hold the button. open flash; light. close when released

FCC Statement

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions.

1. This device may not cause harmful interference. and
2. This device must accept any interference received. including interference that may cause undesired operation.

FCC Radiation Exposure Statement:

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates. uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures.

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

ISED RSS Warning/ISED RF Exposure Statement ISED RSS Warning:

This device complies with Innovation, Science, and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

ISED RF exposure statement:

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated to meet general RF exposure requirements.