Arissa Unslotted Sprung Basin Waste Instruction Manual

Unslotted Sprung Basin Waste

Product Information

The basin waste is a component used in sink installations to
control the flow of water. It consists of several parts:

1. Cover Cap
2. Washer
3. Spring
4. Waste body
5. Washer
6. Rubber Gasket
7. Back Nut

This product is designed with modern plating techniques to
ensure durability and a sleek surface finish. However, it is
important to clean the product correctly to avoid damaging the
surface and maintaining the warranty.

Product Usage Instructions

1. Before installation, ensure that all components are
   present.
2. Fit the waste body (4) and washer (5) to the sink.
3. Fit the Rubber Gasket (6) underneath the sink as shown in the
   diagram.
4. Tighten the Back Nut (7) to secure the Rubber Gasket.
5. Attach the Cover Cap (1) to the brass Click-clack spring
   (3).
6. Check all joints and connections for leaks.

Note: It is important to avoid using corrosive
or abrasive agents/materials on the surface finish of the basin
waste, as it can invalidate the product warranty. Instead, maintain
the surface by using a clean damp cloth.

Basin waste – General Instruction
Parts:
1. Cover Cap 2. Washer 3. Spring 4. Waste body 5. Washer 6. Rubber Gasket 7. Back Nut
Installation: I. Identify all components are present prior to installation II. Fit the waste body (4) and washer (5) to the sink III. Fit the Rubber Gasket (6) to the underneath of the sink as
shown in the diagram, secure by tightening the Back nut (7) IV. Fit the Cover Cap (1) to the brass Click-clack spring (3) V. Check all joints and connections for leaks Aftercare:
Whilst modern plating techniques are used in the manufacture of this product, the surface will be affected if cleaned incorrectly. Surfaces should be maintained using a clean damp cloth, NO corrosive and abrasive agents or materials should be used or come into contact with the surface finish, or this will invalidate your product warranty.