Arissa Brushed Brass Click Clack Unslotted Basin Waste Instructions

Brushed Brass Click Clack Unslotted Basin Waste

Basin Waste – General Instruction

This product consists of the following parts:

1. Cover Cap
2. Washer
3. Spring
4. Waste Body
5. Washer
6. Rubber Gasket
7. Back Nut

Installation Instructions:

1. Before installation, ensure that all components are
   present.
2. Fit the waste body (4) and washer (5) to the sink.
3. Fit the Rubber Gasket (6) to the underneath of the sink as
   shown in the diagram.
4. Secure the Rubber Gasket by tightening the Back Nut (7).
5. Fit the Cover Cap (1) to the brass Click-clack spring (3).
6. Check all joints and connections for leaks.

Aftercare Instructions:

While modern plating techniques are used in the manufacture of
this product, the surface will be affected if cleaned incorrectly.
To maintain the surface, use a clean damp cloth. Do not use any
corrosive or abrasive agents or materials as they may damage the
surface finish and invalidate your product warranty.

Basin waste – General Instruction
Parts:
1. Cover Cap 2. Washer 3. Spring 4. Waste body 5. Washer 6. Rubber Gasket 7. Back Nut
Installation: I. Identify all components are present prior to installation II. Fit the waste body (4) and washer (5) to the sink III. Fit the Rubber Gasket (6) to the underneath of the sink as
shown in the diagram, secure by tightening the Back nut (7) IV. Fit the Cover Cap (1) to the brass Click-clack spring (3) V. Check all joints and connections for leaks Aftercare:
Whilst modern plating techniques are used in the manufacture of this product, the surface will be affected if cleaned incorrectly. Surfaces should be maintained using a clean damp cloth, NO corrosive and abrasive agents or materials should be used or come into contact with the surface finish, or this will invalidate your product warranty.