CH11-R Remote Control
CH11-R Remote Control Instructions
1. Product Overview
Product Name: Remote Control
Product Model No.: CH11-R
FCC ID: 2BA76CH11MNT001
2. Environment Requirement
Operation temperature: +10~ +40.
Storage temperature: 10~65.
Operating Humidity: 10%~80%RH
non-condensing.
Storage Humidity: 10%~85%RH non-condensing.
3. Directions for Operation
3.1 Pairing Remote
To pair the remote, unplug the bed from the power source, then
press and hold HEAD DOWN and FLAT Buttons simultaneously until the
blue backlights of the remote control are off.
3.2 ADJUST
The adjust button is used to adjust the position of the bed.
Press the adjust button to move the bed up or down as desired.
The one touch button can be used to quickly adjust the bed to a
pre-set position. Press and hold the one touch button until the bed
reaches the desired position.
3.4 UNDERNEATH LED LIGHTING
The underneath LED lighting can be turned on or off using the
corresponding button on the remote control.
Make sure to read the user manual carefully before using the
remote control to ensure proper usage and avoid any damage to the
product.
CH11-R Remote Control Instructions
1. Product Overview
Product Name
Remote Control
Product Model No. CH11-R
FCC ID:
2BA76CH11MNT001
2. Environment requirement Operation temperature: +10~ +40. Storage temperature: 10~65. Operating Humidity10%~80%RHnon-condensing. Storage Humidity10%~ 85%RHnon-condensing.
3. Directions for Operation 3.1 Pairing Remote Unplug the bed from the power source,then press and hold HEAD DOWN and FLAT Buttons simultaneously until the blue backlights of the remote control are off.
3.2 ADJUST:
3.3 ONE TOUCH BUTTON:
3.4 UNDERNEATH LED LIGHTING
4. Matters needing attention 4.1 The function will only work normally in proper working power conditions. 4.2 Remote Control needs three AAA batteries. 4.3 The control box is needed for proper control. 4.4 If problems are identified, they must be treated by professional personnel. 5. Additional attention for user 5.1 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: –Reorient or relocate the receiving antenna. –Increase the separation between the equipment and receiver. –Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. –Consult the dealer or an experienced radio/ TV technician for help.
5.2 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 5.3 For Intentional and unintentional radiators the manual shall caution the user and manufacturer that changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
