P5352-1-084-L 24 Inch 1 Light Brushed Nickel LED Vanity Light
Product Information
The P5352-X-084-L is a wall-mounted fixture designed for indoor
use. It comes with a mounting plate, ground screw, mounting screw,
and fixture body. The fixture is dimmable with ELV and/or LED
compatible wall dimmer switch.
Product Usage Instructions
- Before starting the installation, shut off power at the fuse
box or circuit breaker box. - Remove the old fixture, including the mounting hardware.
- Carefully unpack the new fixture and lay out all the parts on a
clear area. - Secure the mounting plate to the junction box using the
provided mounting screws. Make sure the side of the mounting plate
marked GND faces out. - Connect the electrical wires as shown in Fig. 2. Ensure that
all wire connectors are secured. If your junction box has a ground
wire, connect the fixture’s ground wire to it. Otherwise, connect
the fixture’s ground wire directly to the mounting plate using the
green screw provided. - Tuck wire connections neatly inside the junction box.
- Place the fixture body onto the mounting plate and secure it
with screws. - Turn on the power to the junction box and test the
fixture.
When handling the fixture, avoid applying pressure to the LEDs.
Hold the fixture by the base or fixture body only.
Note: It is recommended to have the fixture installed by a
qualified electrician to ensure proper wiring and installation.
INSTALLATION INSTRUCTIONS FOR P5352-X-084-L
For Wall Mounted Fixture
W ARNI NG ! S HUT POWER OFF AT FUSE O R CIRCUIT BRE AKE R.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARATION
1. Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to misplace any small parts necessary for installation
Fig. 1 Mounting Plate Set #: A-021-140113 for P5352-1-084-L/P5352-2-084-L
-Mounting plate (B)
-Ground screw (F)
-Mounting screw (E)
MOUNTING THE FIXTURE (Fig. 1)
3. Secure mounting plate (B) to junction box (A) (not included) using mounting screws (E) (Size: #8-32*1/2″L). The side of the mounting plate marked “GND” must face out.
CONNECTION THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your junction box (A) has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (B) using the green screw provided. 5. Tuck wire connections neatly inside the junction box.
FINISHING THE INSTALLATION (Fig. 1)
6. Place fixture body (G) to mounting plate (B) and secure with screws (D).
Your installation is now complete. Return power to the junction box and test the fixture.
CAUTION / ATTENTION: When handling the fixture, do not apply pressure to the LEDs. Hold the fixture by the base or fixture body only.
IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer switch.
Fig. 2
FIXTURE WIRES Black or Smooth
FIXTURE WIRES White or Ribbed
FIXTURE WIRES Bare Copper (Ground)
HOUSE WIRES Black (Hot)
HOUSE WIRES White (Neutral)
HOUSE WIRES Green (Ground)
