WPC-4000 Portable Air Conditioner

Product Information

Product Name: WPC-4000

Product Type: Air Conditioner

Maintenance

FILTER CLEANING

There are two filters in the unit:

1. Evaporator Filter: Located at the front of the
   unit.
2. Condenser Filter: Located at the side of the
   unit.

Usage Instructions

1. Loosen up the 2 bolts on the front filter guard.
2. Slide the filter up and use a vacuum cleaner to remove the dust
   from the filter.
3. If the filter is heavily covered with dust and dirt, clean it
   with warm water and mild soap or neutral detergent.
4. Do not operate the unit without the filter fitted.
5. Do not operate the unit with a damaged cord or plug.
6. Do not operate the unit if it malfunctions.
7. Do not operate the unit if it has been dropped or damaged.

Owner’s Manual

WPC-4000

Maintenance
FILTER CLEANING (See Figures 9 and 10)

There are two filters in the unit. The evaporator filter is located at the front of the unit. The condenser filter is located at the side of the unit. 1. loosen up 2 bolts on the front filter guard. 2. Slide filter up and use a vacuum cleaner to remove the dust from the filter. 3. If the filter is heavily covered with dust and dirt, warm water and mild soap or neutral deter-
gent may be used to wash the filter. Do not use any other chemicals to clean filter, as they will likely damage the filter. 4. Dry the filter in a shaded area before replacing it. Do not operate the unit without the filter installed and the filter guard in the closed position. 5. Replace the clean filter and close the filter guard. 6. To clean the condenser filter, lift up on the side filter from the middle bar slightly and then angle the filter outwards from the bottom and remove. 7.Use the same cleaning procedure as above (3 ­ 5). 8. To replace the condenser filter, place the top of the filter in the guide and slide the filter up until the bottom of the filter clears the frame. Then push the bottom of filter into the guide and let filter gently fall inside the guide. NOTE: For effective cooling clean the filter at least every 2 weeks.

­ Loosen up 2 bolts on the front filter guard.
­ Slide filter up and use a vacuum cleaner to remove the dust from the filter.

Figure 9 ­ Removing Filters

Figure 10 ­ Removal of Dust

­ Remove dust from the filter using a vacuum cleaner hose aachment.
­ If required wash the filter in lukewarm water with a mild detergent. Leave to dry in a shaded area before reinstalling.

Do not operate without the filter fitted. Do not operate the unit with a damaged cord or plug, after the unit malfunctions, or if the unit has been dropped or damaged.

­ For your convenience, record the complete model number and product name (located on the Product Identification Plate), the purchase date, purchase location, serial number, and warranty period in the table below.
­ Also, attach your purchase receipt as proof of purchase to this instruction manual for future reference.
­ To ensure your product is covered by warranty, the complete faulty product along with your original purchase receipt must be provided at the place of purchase.

7