Motorized Roller Shades with Cassette
Product Information
The product is Motorized Roller Shades with Cassette. It comes
with brackets for installation, offering two methods of
installation: Top-Fixing and Face-Fixing. The brackets should be
positioned at least 5cm away from the ends of the rail, with any
other brackets evenly distributed across the width. The cassette
has a T-shaped lip on the top that needs to be situated into the
front lip of the bracket. Once positioned, twist the back of the
cassette upwards until it snaps into place against the back lip of
the bracket.
For Motorized Roller Shades with Exposed Roll, the controls can
be positioned as requested during the ordering process, but can
also be easily removed and repositioned. The brackets offer three
methods of installation: Top-Fixing, Face-Fixing, and Side-Fixing
(only recommended if the width measurement was taken at the top of
the recess).
Product Usage Instructions
Installation Guide for Motorized Roller Shades with
Cassette
- Decide on the installation method: Top-Fixing or
Face-Fixing. - Position the brackets at least 5cm away from the ends of the
rail, with any other brackets evenly distributed across the
width. - Fix the brackets to the desired location using screws.
- Hold the rail at an angle and situate the T-shaped lip on the
top of the cassette into the front lip of the bracket. - Twist the back of the cassette upwards until it snaps into
place against the back lip of the bracket.
Installation Guide for Motorized Roller Shades with Exposed
Roll
- Decide on the installation method: Top-Fixing, Face-Fixing, or
Side-Fixing (only if width measurement was taken at the top of the
recess). - Position the brackets according to the chosen installation
method and fix them securely using screws. - Prior to fixing the brackets, if needed, remove the controls by
unplugging them from the tube. - Once the brackets are fixed, locate the depression end of the
blind and insert it into the cross-shaped hole in the corresponding
bracket. - Lift the control end of the blind and slot the rectangular lugs
into the corresponding slots on the bracket.
Installation Guide
Motorized Roller Shades with Cassette
The brackets offer two methods of installation:
Top-Fixing
Use the front two holes in the top of the bracket to fix to the lintel (the `ceiling’ of the recess).
Face-Fixing
Use two screws through the back plate to mount onto a facing surface (a wall or window frame)
5cm
5cm
Note that the position of the outermost brackets should be at
least 5cm away from the ends of the rail, with any other
brackets evenly distributed across the width.
Bracket (side-on)
Shade (side-on)
Holding the rail at an angle, situate the T-shaped lip on the top of the cassette into the front lip of the
bracket.
Twist the back of the cassette upwards until it snaps into place against the back lip of the bracket.
Before you begin Fitting the brackets
Installation Guide Motorized Roller Shades with Exposed Roll
We will have positioned the controls where you requested during the ordering process. However if you decide to swap the side that they are on, direction of the roll or need to trim the blind further, the controls can be removed by simply unplugging them from the tube. This should be done prior to fixing the brackets.
The brackets offer three methods of installation:
Top-Fixing
Where the brackets are screwed into the lintel (or
`ceiling’ of the recess)
Face-Fixing
Where the brackets are screwed onto a facing surface
(a wall or window frame)
Side-Fixing
Where the brackets are screwed into the side walls of
the recess
Top Tip
Top-fixing or face-fixing are recommended for most installations, whereas side-fixing is only recommended if the width you gave us was taken right at the top of the recess.
Fitting the blind
Locate the depression end (the opposite end to the controls) of the blind into the cross-shaped hole in the corresponding bracket.
Lift the control end of the blind and slot the rectangular `lugs’ into the corresponding slots on the bracket.
