- Unplug machine
- Remove clean water tank
- Fill with water
- Reattach cap and insert
- Hold tank upside down over sink to check for leaking
- If leaking, a new cap and insert will need to be ordered
- Remove dirty water tank
- Check for water in the receiving area where the tank sits
- If there is water in this area, check that the duck bill gasket is installed properly
- Turn the dirty water tank upside down and right side up several times
- Does the float inside the tank move freely when turning the tank?
- If not, clean with warm water
- If float is still stuck, a new tank needs to be ordered
- Secure hose to the BarkBath tool tightly
- Secure cap on tool tightly
- Residual water will remain in hose the after use
- Hold hose over sink with tool end towards the ceiling to release any water that accumulates
- Water may drain from spray tips on the tool when placed on floor
- To prevent drainage, rotate tool head side-to-side to drain excess water from the spray tips before placing on the ground
- Check for tears or cracks in hose
- If there is damage on hose, a new tool/hose will need to be ordered
- If there is still leaking, Contact Us
