43810 LED Driver Constant Voltage
Product Information
This product is a Constant Voltage LED Driver used for powering
LED lights. It has a maximum load capacity of 10W and operates at
240V ~ 50Hz. The LED driver is double insulated and does not
require connection to an Earth circuit. The product is manufactured
by Saxby Lighting and the model number is 43810. The product can be
recycled and should not be disposed of with household waste.
Usage Instructions
Commissioning: Before use, parallel the correct
configuration of LED lights being fitted and ensure that the total
wattage of these units does not exceed 10W.
Fitting: The LED driver can be fitted directly
or plugged into an existing fitting. If fitting directly, ensure
that the cables will reach the distances between the LED driver and
each LED fitting. We recommend a maximum total cable length of 5.0m
on the low voltage side. If plugging in, carefully note the
position of each set of wires and the system to which they connect.
Do not connect at this stage. Ensure that the LED driver can be
accessed and that no loose strands have been left out of the
connection.
Cleaning: We recommend cleaning the product
with a soft dry cloth. Never use scourers, abrasives or chemical
cleaners.
Recycling: The product can be recycled and
should not be disposed of with household waste. Please recycle
where facilities are available.
Safety Information: Please read the instruction
leaflet carefully before installing or maintaining this product.
Install in accordance with IEE Wiring regulations and seek help
from an electrician if needed. Ensure that no loose strands have
been left out of the connection and that the negative terminal is
correctly connected.
Warning: This LED driver is double insulated
and must not be earthed.
Specification: The product layout should be
planned carefully to ensure that the cables will reach the
distances between the LED driver and each LED fitting. The mains
cable should be the longer length in the layout.
Check: Check that no loose strands have been
left out of the connection before using the LED driver.
Commissioning
parallel the correct configuration.
being fitted and the total wattage of these units. We recommend a maximum load of 10W for the LED Driver.
240V ~
50Hz
Constant Voltage LED Driver
+ _
LED driver is now ready for use.
Fitting +_
Fitting +_
Fitting +_
We recommend cleaning with a soft dry cloth. Never
use scourers, abrasives or chemical cleaners.
Recycling advice
Safety information
cleaning.
Instruction leaflet
LED Driver Constant Voltage
43810
UK Manufacturer: BH17 7BY EU Manufacturer: Brilliant AG, Brilliantstrasse 1, D-27442 Gnarrenburg
www.saxbylighting.com
V2 17/06/2021 Saxby Lighting
Warning
This LED driver is Double Insulated and does not require connection to an Earth circuit. Please read these instructions carefully before
electrician. Install in accordance with IEE Wiring regulations and
before installing or maintaining this fitting. Ensure
with household waste. Please recycle where facilities recycling advice.
Specification
Layout
ensuring the cables will reach the distances between the LED driver and each LED fitting.
driver. damaged.
layout so that the mains cable is the longer length. We recommend that a maximum total cable length of 5.0m is used on the low voltage side.
Direct Wiring
existing fitting, carefully note the position of each set of wires.
the system will connect to. Do not connect at this stage. Ensure that the LED driver can be accessed
loose strands have been left out of the connection ensuring that
loose strands have been left out of the connection
the negative terminal.
Plug Wiring
This LED driver is double insulated and must not be earthed.
or is removed for any other reason, then the cut off
BL Neutral
Live
E L
Fuse
N
Check that…
No loose strands have been left out of the connection
Saxby Lighting - Commercial and Domestic Lighting Supplier
