Megatron Mt68002 Wing Plus Led Wall Luminaire Instruction Manual

MT68002 WING Plus LED Wall Luminaire

LED Wall Luminaire – WING+ Series

The WING+ series offers two models: MT68002 and MT68003. These
wall luminaires have a wattage of 4.5W and an energy efficiency
class of E. The light source provides 500lm and is approximately
11mm in size. The product contains 250lm and operates on a voltage
of 220-240V AC with a frequency of 50Hz. The IP Rating of the
product is IP54.

Usage Instructions:

1. Select a suitable location on the wall where you want to
   install the WING+ luminaire.
2. Ensure that the voltage and frequency of the electrical outlet
   match with the product specifications.
3. Turn off the power supply before installing the luminaire.
4. Unpack the product and remove all packaging materials.
5. Attach the mounting bracket to the wall using screws and
   anchors (not included).
6. Connect the wires from the luminaire to the electrical outlet
   following the wiring diagram provided in the manual.
7. Secure the luminaire to the mounting bracket using screws
   (included).
8. Turn on the power supply and test the luminaire.
9. If everything works fine, adjust the direction of the light
   beam as per your requirement.

CAUTIONS:

• Do not install the luminaire in a location where it will be
  exposed to direct sunlight or rain.
• Do not use abrasive cleaners or solvents to clean the
  luminaire.
• Do not touch the luminaire with wet hands or when it is
  connected to the power supply.
• Do not modify the product in any way.
• If you notice any damage to the luminaire, contact a qualified
  electrician immediately.

LED Wall Luminaire -WING+

Series Name

WING+

WING+

Model Number

MT68002

MT68003

Wattage Light source energy efficiency class <X>
Lumen Light Source

4,5W E 500lm

4,5W E 500lm

approx. 11mm

Lumen Containing Product Voltage Frequency

250lm 220-240V AC 50Hz

250lm 220-240V AC 50Hz

IP Rating

IP54

IP54

CAUTIONS
· Read the entire manual carefully before installation and operation. · Installation or replacement should be performed only by licensed and qualified electricians. · DO NOT disassemble the inner part of the luminaire. Doing so may result in lamp damage or malfunction. · Switch off the power source before installation, replacement and cleaning! · Wearing gloves during installation is recommended to ensure the luminaire is kept in the best condition. · Before replacement of the luminaire, turn it off and allow it cool down. Heat-resistant gloves are mandatory when handling the luminaire. · The driver contained in this luminaire shall only be replaced by a qualified electrician, and must be in compliance with the local installation regulations. · DO NOT cover luminaire when in use. · The manufacturer accepts no liability for any damage resulting from the misuse of the luminaire or from when is it used with inappropriate equipment.
Important warning when drilling in walls: Before drilling, make sure that there are no gas, water or power lines at the drilling site. Installation only by competent persons. Be sure to pay attention to the wall condition, as the attached mounting material is not suitable for all wall types suitable. Inquire at retailers about the screws and dowels suitable for the respective wall condition. The manufacturer accepts no liability for any resulting damages from improper wall dowel. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person. This product contains a light source of energy efficiency class <E > · Consult your dealer if you have any enquiries.