Instruction Manual
YL-37 Remote Control
Mode switching ke
Function conversion
Remote control car default function Forward – Backward – Turn Left – Turn Right
- Click the mode switch key
Forward-Backward – Drift Left – Drift Right - Click the mode switch key
Automatic presentation
Press the mode button for 3 seconds to enter automatic demo mode (Press the function key once to restore the default mode) 
| Frequency band | 2410 MHz ~ 2473 MHz |
| Integrated Chipset | RF2420 |
| OSC | 12MHz |
| Channels | 32CH |
| Modulation | GFSK |
| Antenna | 0dBi |
| Antenna Type | Internal Antenna |
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to protect reasonably against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirements.
