Cake Topbox Plate Adapter Instructions

Topbox Plate Adapter

Product Information: Makka Topbox Plate Adapter

The Makka Topbox Plate Adapter is an accessory designed for use
with the top box kit. It includes four screws, four nuts, four
washers, and a top box plate adapter for easy attachment of the top
box kit. The adapter comes with a set of tools needed for
installation, including a hex key 5 mm, hex key 6 mm, wrench 10 mm,
and wrench 13 mm.

Product Usage Instructions

1. Start by removing the rear seat from your bike.
2. Using the hex key 5 mm and wrench 10 mm, remove the four bolts
   located on the rear fender.
3. Place the Makka Topbox Plate Adapter on top of the rear fender
   and align the holes with the holes on the fender.
4. Insert the screws and washers through the holes on the adapter
   and tighten them with the hex key 6 mm and wrench 13 mm.
5. Attach the top box kit to the adapter using the included
   fasteners (four MC6S M8x20 screws, four nut nylock M8, and four
   washer M8).
6. If needed, use the remaining four MC6S M6x20 screws, four nut
   nylock M6, and four washer M6 to further secure the adapter to the
   fender.
7. Replace the rear seat and ensure it is securely fastened.

If you encounter any issues during installation or have
questions about this product, please contact your local CAKE
service center for support.

Makka topbox plate adapter Instructions

These holes is to be used for the topbox attachment included in top box kit

Items Component

1

Topbox plate adapter

2

Washer

3

Nut ­ torqued to 15 Nm

4

Nut ­ torqued to 10 Nm

5

Screws

Please contact your local CAKE service center if you need support

Fasteners included 4x MC6S M8x20 4x nut nylock M8 4x washer M8 4x MC6S M6x20 4x nut nylock M6 4x washer M6
Tools needed Hex key 5 mm Hex key 6 mm Wrench 10 mm Wrench 13 mm