PR-45563-HPHNL Pressure Injectable Arrowg+ard Blue Advance
Contents
- Three Lumen TaperFree® Catheter with Arrowg+ard Blue Advance® Antimicrobial/Antithrombogenic
- Protection1: 6 Fr. (2.11 mm OD) x 55 cm, Pressure Injectable, Blue FlexTip®
- GlideThru™ Peel-Away Sheath: 6 Fr. x 4″ (10 cm) Radiopaque over 6 Fr. Dilator
- Spring-Wire Guide, Nitinol, Marked: .018″ (0.46 mm) dia. x 17-3/4″ (45 cm) (Straight Soft Tip on One End – Straight Stiff Tip on Other)
- Guidewire, Marked: .018″ (0.46 mm) dia. x 130 cm Hydrophilic-Coated Nitinol with Soft Tip Tungsten Coil
- Introducer Needle: Echogenic 21 Ga. x 2-3/4″ (7 cm) TW
- Syringe: 10 mL Luer-Lock
- Skin Protectant Prep
- Dust Cap: Non-Vented
- SecondSite™ Adjustable Hub: Fastener
- SecondSite™ Adjustable Hub: Catheter Clamp
- Catheter Trimmer
- Safety Scalpel: #11
- Patient ID Card
- Chart Sticker
- Patient Information Booklet
- Checklist/CLIP Sheet
- Paper Tape Measure
- Dressing: STATLOCK®2 Catheter Stabilization Device
- Licensed under US Patent No. 7,329,412.
Warning:
Read all package insert warnings, precautions, and instructions prior to use. Failure to do so may result in severe patient injury or death. www.teleflex.com/IFU
WARNING:
Cancer and Reproductive Harm. www.P65Warnings.ca.gov
Not made with natural rubber latex.Store below 25°C (77°F). Avoid excessive heat above 30°C (86°F). Fluid path components are non-pyrogenic.
Contraindications:
The Pressure Injectable Arrowg+ard Blue Advance antimicrobial/antithrombin biogenic catheter is contraindicated:
- for patients with known hypersensitivity to chlorhexidine
- in the presence of device-related infection in the intended insertion vessel or catheter pathway
- in the presence of thrombosis in the intended insertion vessel or catheter pathway
- Priming volumes are approximate and are done without accessories.
- Flow rate values are approximate and are determined using deionized water at 100 cm head height.
- Pump flow rates are determined at a maximum pump pressure of 10 psig and represent approximate flow capabilities.
- Pressure injection flow rates are determined at the injector pressure setting of 300 psi maximum using media of 11.8 centipoise viscosity, with 152 cm pressure tubing.
