Pentair Csburcxx Caddy Sway Bracing Instructions

PENTAIR CSBURCXX CADDY Sway Bracing

Product Information: CADDY Sway Bracing

The CADDY Sway Bracing is available in various models:

• CSBURCXX
• CSBURCRXX
• CSBURC48XX
• CSBNPC12

Part Numbers and Article Numbers:

Product Usage Instructions

Section 1: CSBURCXX, CSBURC48XX

• Step 1: Insert the fastener with washer through the fastener hole and tighten the CSBURC to the structure.
• Step 2: Insert the cable through a sleeve (ferrule), then through CSBURC, and back through the sleeve (ferrule).
• Note: Step 1 can be alternated with Steps 2 and 3, it is up to the installer’s preference.
• Step 3: The sleeve (ferrule) has to be swaged by using a swaging tool (CSB3346SB, CSB13SBHS, CSB48, or CSBHS02). Refer to the tool manufacturer’s instructions for the number of swages needed per cable.

Section 2: CSBURCRXX

• Step 1: If using Red, #12, 3/32in (2.4mm) cable, use 1 each CSBURCR. If using White, #18, 1/8in (3.2mm) cable, use 2 each CSBURCR’s.
• Step 2: Loosen the nut on the fastener that the CSBURCR will be used with. Slide the CSBURCR in-between the washer and mounting surface.
• Step 3: Tighten the nut until tight.
• Step 4: Insert the cable through a sleeve (ferrule), then through CSBURCR, and back through the sleeve (ferrule).
• Note: Steps 2 and 3 can be alternated with Steps 4 and 5, it is up to the installer’s preference.
• Step 5: The sleeve (ferrule) has to be crimped by using a swaging tool (CSB3346SB, CSB13SBHS, CSB48, or CSBHS02). Refer to the tool manufacturer’s instructions for the number of swages needed per cable size.

Please refer to the product instruction sheets and training materials for detailed installation and usage guidelines. These materials can be found at www.erico.pentair.com.

WARNING:

1. Pentair products shall be installed and used only as indicated in Pentair product instruction sheets and training materials. Instruction sheets are available at www.erico.pentair.com. Failure to follow these instructions may result in product damage, serious bodily injury, and/or death, and void your warranty.
2. Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment.
3. All pipe supports, hangers, intermediate components, and structural attachments must ONLY be used as described herein and are NEVER to be used for any other purpose.

Pentair, CADDY, ERICO CADWELD, ERICO CRITEC, ERICO, ERIFLEX, and LENTON are owned by Pentair or its global affiliates. All other trademarks are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.