Homedepot Selectable LED Flush Mount Ceiling Light with Remote Control
Directions
- Please cut off the electricity supply and press the “off” button before installing this item.
- This item should be installed by an electrician.
- Except for the accessory accessories, can not put any other accessories or Insulation accessories on the lighting
- Can not install extra bulbs.
- The lighting will be getting hot after turning on, please caution.
- The lighting should be installed on a non-conductive surface.
Installation Directions
- Step1 Use plank to find the suitable holes for installing the lighting on the mixed soil ceiling
- Step2 Make holes with a hole punch, then put the expansion bolt inside
- Step 3 install the plank smoothly, then put the flat gasket and spring shim on the expansion bolt, then screw tie.
- Step 4 connect to the home use Power Cord and earth wine
Note:
- If the ceiling is made of wood, there is no need to make holes with a hole punch.
- This lighting can not be installed on a plaster ceiling!
- After installation should try test some stuff which 4 times heavier than this lighting.
Description of remote control and lamp body matching The wall switches on the light (note: it will be finished within 3 seconds after the light is on.) press the number 1 key on the remote control to turn on, and the light will blink 3 times. Indicates that the match is successful, and the function
on other keys can be used normally.
Warm tips: the lamp body and the remote control have been matched well when they are manufactured. After power is installed, the function buttons on the remote control can be used directly 
