If you are experiencing No/Low Spray to the hose, follow these steps to resolve:
- Turn off and unplug machine
- Remove Hose & keep machine in the upright position
- Clean the spray tip at the end of the hose with a soft brush (old toothbrush)
- Remove the front nozzle by lifting under the hose access door and pulling up
- To Prime, use a standard ball point pen to press into the small circular opening until water comes out
- Place the pen in the black cylinder next to the screw
- When water bubbles up, remove the pen
- Reassemble the nozzle
- Line up the three hooks on the nozzle to the bottom of the foot
- Machine may have to be leaned back slightly to install correctly
- Rotate the nozzle up and click into place
- Reinsert the hose
- Be sure the colored hose release clip is facing out, away from machine
- Keep the hose below the upper water tank or lay hose flat on the floor
- Remove tool at the end of the hose
- Plug machine in and turn on
- Retry pressing hose trigger for up to 20 seconds while machine is on – it may blow out pockets of air
- Is there spray coming out of the spray tip?
- No > Go to Changing the Belt
- Yes > Reattach tool and test for spray with tool
- Is there spray with tool?
- Yes > Great! Glad we could get you back to cleaning!
- No > A new tool should be ordered > Go to Parts & Supplies
- Is there spray with tool?
