ERI-PB-403-A Round White Vitreous China Modern Pedestal Sink Combo
Product Information
This product is a one-piece pedestal sink designed for
installation in bathrooms. It comes with an installation guide that
provides step-by-step instructions on how to properly install the
sink.
Tools and Materials
- Safety Glasses
- Pencil
- Wrench
- Caulk
- Construction Adhesive
Prior to Installation
Before installing the sink, please take note of the
following:
- Unpack the sink and inspect it for any damage.
- Familiarize yourself with the local plumbing and building
codes. - Ensure that the floor and wall are prepared adequately to avoid
product damage. - Check if the sink will fit in the intended location and if
plumbing fixtures are in the correct position. - Measure the actual dimensions of the sink before
installation. - It is recommended to have two people for the installation
process.
Installation Procedures
STEP I. Verify Sink Location
Use a pencil to mark the location on the floor where the sink is
intended to be installed.
STEP II. Install Plumbing
Follow the manufacturer’s instructions to install the faucet
(not included). Connect the plumbing pipes in the wall to the
pedestal sink (plumbing pipes not included). Test fit the pedestal
sink before proceeding to the next step.
STEP III. Seal Sink (2 People Required)
Person 1: Tilt the sink slightly backward so that the pedestal
sink partly lifts off the ground.
Person 2: Apply construction adhesive underneath the sink.
Lower the sink back to its standing position with care and apply
a bead of silicone sealant between the floor and the sink.
NOTE: Allow the silicone up to 24 hours to fully dry before
using the pedestal sink.
Installation Guide
ONE-PIECE PEDESTAL SINK
Installation Guide
Tools and Materials
Safety Glasses
Pencil Wrench
Caulk
Construction Adhesive
Prior to Installation
Read the following instructions thoroughly before installation of the sink:
1.Unpack the sink and inspect it for damage. 2.Observe all local plumbing and building codes. 3.Additional preparations on the floor and wall may be necessary to avoid product damage. 4.Confirm that the sink will fit in the intended location and that plumbing fixtures are located where legally required prior to installation. 5.Make sure to measure the actual dimensions of the sink prior to installation. 6.It’s recommended that the sink be installed by two people.
Installation Procedures
STEP I. Verify Sink Location
Mark the location on the floor with a pencil where the sink is intended to be installed.
01
Installation Guide
STEP II. Install Plumbing
Install the faucet as per the manufacturer’s instructions. (faucet not included) Connect the plumbing pipes in the wall with the pedestal sink. (plumbing pipes not included) Test fit the pedestal sink before proceeding with the next step.
STEP III. Seal Sink (2 People Required)
Person 1 – Tilt the sink backward slightly so the pedestal sink partly lifts off ground. Person 2 – Apply construction adhesive underneath the sink. Lower the sink back to its standing position with care and apply a bead of silicone sealant between the floor and the sink.
NOTE Allow the silicone up to 24 hours to fully
dry before using the pedestal sink.
02
Installation Guide
© COPYRIGHT 2023 ERIDANUS
