Havit Lighting Hv5877t-wht Slim Led Oyster Light Instruction Manual

HAVIT Lighting HV5877T-WHT Slim LED Oyster Light

Product Specifications

DIMENSION

Important Safety Issues

• This product must be installed by a qualified electrician according to AS/NZS 3000.
• Ensure all electrical mains are disconnected before any installation.
• Modification of this product will void any warranty.
• Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system. Aluminum and 3045S fittings must not be installed within 5km of any saltwater environments.
• All o-rings and seals must be in place correctly to maintain a warranty
• This form may be updated at any time due to product improvements, please check the online installation form for the most current version.

Steps for Installation

1. Make sure that the electrical circuit is free of voltage (master switch off)
2. Remove base plate from fitting by twisting anti-clockwise.
3. Insert cable through centre hole of fitting
4. Install base plate to ceiling in desired location using appropriate screws for application.
5. Connect the cable – connect live and then neutral wire.
6. Fitting is preset to 3000k, to change slide switch located in base of fitting to desired colour temperature.
7. Reattach fitting to base plate making sure screws are tight to avoid water penetration.
8. All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.

Must be installed by a licensed electrician

Contact Details

143 Beauchamp Road Matraville NSW 2036 Australia

• Tel: 02 9381 8300
• Fax: 02 9666 8881
• Email: [email protected]
• Web: www.havit.com.au