Avantco 177DHC13 Gallon Beverage Dispensers
IMPORTANT Safeguards
- When using electrical appliances, basic safety precautions should always be followed including the following:
- Read all instructions
- Close supervision is necessary when any appliance is used by or near children.
- Make sure the appliance is OFF when not in use, before putting on or taking off parts, and before cleaning.
- Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair or electrical or mechanical adjustment.
- Do not use outdoors.
SAVE THESE INSTRUCTIONS
Parts Diagram
| Parts Key | ||
| Parts Diagram # | Part Name | Replacement Part Item # |
| 1 | Lid | 177PDHCLID |
| 2 | Bowl | |
| 3 | Mixing Auger | |
| 4 | Bowl Hook-on Handles | |
| 5 | Dispenser Housing | |
| 6 | Power Switch | 177PDHCPS |
| 7 | Thermostat | 177PDHCTHRM |
| 8 | Lower Dispenser Housing | |
| 9 | Paddle | 177PDHC13P (DHC-13), 177PDHC26P (DHC-26) |
| 10 | Pan | |
| 11 | Lid for Boiler Tank Water Level Indicator Tray | |
| 12 | Boiler Tank Water Level Indicator Tray | |
| 13 | Tap Handle | 177PDHCHNDL |
| 14 | Drip Tray Maximum Level Indicator | |
| 15 | Drip Tray Grid | |
| 16 | Drip Tray | |
| 17 | Boiler Tank Drainage Cap | |
| Not Pictured | Bowl Gasket | 177PDHCBG |
| Not Pictured | Heating Element | 177PDHCELM |
| Not Pictured | Faucet Gasket | 177PDHCGF |
| Not Pictured | Faucet Screw Gasket | 177PDHCGFS |
| Not Pictured | Interior Faucet Gasket | 177PDHCGI |
| Not Pictured | Motor | 177PDHCMTR |
operating Instructions
Before the machine may be started up for the fi rst tlme, speciallzed tech local personnel must check that It funetions properly.
Starting Up
- To start up the machine carry out the following steps:
make sure that the main switch is set to off, take off the lid; Fig.6 - fill the boiler tank with water using the boiler tank level indicator tray, until it reaches the maximum value indicated on the tray itself, which is marked MAX; Fig.7
Warning: fill the boiler tank by pouring in water slowly and check for a few seconds to make sure that the water level has rea- Sched the -MAX- level and that it is stable.
When filling an empty boiler tank for the first time, the amount of water needed to completely fill the tank is approximately 3.25 litres (0.86 GAL US).
- remove the lid and pour the beverage prepared accordlng to the manu- facturer’s Instructlons Into the bowl;
- never exceed the maximum level, which is marked-MAX- on the tray itselt
- after pouring the product into the bowl, fit the lid back in place;
- make sure that the plug has been inserted into the mains socket;
- press the main switch to start the machine; the product inside the bowi will start to be mixed: Fig.9
- Set the thermostat to the required temperature to heat the product inside the bowl Fig.9
Avantco Equipment
