ATTENTION – SETTING UP
To set up the Milk Steamer, follow the Instruction Manual provided.
If the Milk Steamer is still not producing steam, follow the instructions below.
- Ensure the Steam Valve is at 0. Turn on by pressing the ON/ OFF Switch. Position the Milk Jug below the Steam Nozzle, remove Water Tank, then the Water Filter Holder & set the Water Filter Holder aside.
- Fill Water Tank halfway (425ml). Place a tea towel in a plastic bag & place it in the Water Tank (1) , above the water level to create a tight fit in the Water Tank (2) . Place the Water Tank back inside the machine (3).
- Press & hold the Descale Button for 5 seconds. The Indicator Light will flash red.
- Turn the Steam Valve fully anti-clockwise. Gently apply downward pressure to the plastic bag; until water comes out of the Steam Nozzle. Note this may take up to 20 seconds. Caution: Steam & Hot Water from the nozzle, risk of scalding.
- Turn the Steam Valve clockwise fully (1) , then remove the plastic bag & tea towel (2)
- With the Water Tank still inside the machine, place the Water Filter Holder back inside the Water Tank.
- Press & hold the Descale Button for 5 seconds. Your Milk Steamer is now ready to use.
Visit dualit.com/cino for the most recent Instruction Manual
Dualit Limited County Oak Way Crawley West Sussex RH11 7ST
+44(0)1293 652 500 | [email protected] | www.dualit.com
