WP36W-CW LED Weatherproof Batten

LED WEATHERPROOF BATTEN

Product Information

The LED Weatherproof Batten is a high-quality lighting solution
designed for both indoor and outdoor use. It comes in different
models with varying power ratings and lumens to suit different
lighting needs. The product is rated IP65, which means it is
dust-tight and protected against water jets from any direction.

• Model No: WP12W, WP18W, WP24W, WP36W, WP30W,
  WP48W
• Rated Voltage: 220-240V~
• Frequency: 50/60Hz
• Rated Power: 12W, 18W, 24W, 36W, 30W, 48W
• Lumens: 1000lm, 1500lm, 2000lm, 3000lm,
  2500lm, 4000lm
• Protection Class: II
• Protection: IP65

Product Usage Instructions

Please follow the instructions below carefully to ensure safe
and proper installation of the LED Weatherproof Batten:

1. This product should only be installed by a registered
   electrician in accordance with national wiring codes.
2. Prior to installation, maintenance, exchanging the LED chips or
   cleaning, ensure that the power supply is isolated.
3. If the external flexible cable of this luminaire is damaged, it
   should only be replaced by the manufacturer or their service agent
   to avoid any hazard.
4. Unscrew the gland (as shown in Picture 1).
5. Use a screwdriver to open the terminal box.
6. Connect the brown wire (L) to terminal L, blue wire (N) to
   terminal N, and earth in accordance with wiring codes.
7. Replace the terminal box cover.

Note: Please retain these instructions for future
reference.

Picture 1:

Certainty at The Speed of Light
INSTALLATION MANUAL
LED WEATHERPROOF
BATTEN
WP18W-CW WP36W-CW

Installation Instructions
Please read the following instructions carefully to ensure that the installation is carried out correctly. These instructions should be retained for future reference.

Specifications

Model no. Rated voltage Frequency Rated power Lumens Protection class Protection

WP12W
12W 1000lm

WP18W
18W 1500lm

WP24W

WP36W

220-240V~

50/60Hz

24W

36W

2000lm

3000lm II

IP65

WP30W

WP48W

30W 2500lm

48W 4000lm

Safety Instructions
1. Use H07RN-F, 2 x 1.0mm² rubber cable.
2. Luminaire should be installed by a registered electrician only, in accordance with national wiring codes. If the external flexible cable of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or their service agent in order to avoid a hazard.
3. The power supply must be isolated prior to installation, maintenance, exchanging the LED chips or cleaning.
4. Picture 1: Un-screw the gland.
5. Use a screw driver to open the terminal box.
6. Connect brown wire (L) to terminal L, blue wire (N) to terminal N and earth in accordance with wiring codes.
7. Replace the terminal box cover.

1

2

3

4