Regency Equipment Stand With Undershelf Instruction Manual

Equipment Stand with Undershelf

Product Information: Equipment Stand with Undershelf

The Equipment Stand with Undershelf is a versatile and durable
stand designed to provide additional storage and support for
various equipment. It is constructed with high-quality stainless
steel, ensuring its strength and resistance to corrosion. The stand
comes with a stainless steel top, an undershelf, legs, and
tightening screws. It is available in two models: a 4-leg table and
a 6-leg table, each offering different load-bearing capacities.

Product Specifications:

• Model: 4-leg table / 6-leg table
• Material: Stainless steel
• Parts included:
  • A (1) Stainless Steel Top
  • B (1) Undershelf
  • C (4) Legs (for 4-leg table) / C (6) Legs (for 6-leg
    table)
  • D (8) Tightening Screws (for 4-leg table) / D (16) Tightening
    Screws (for 6-leg table)

Product Usage Instructions:

1. Prepare the assembly area by ensuring it is clean and on a flat
   secure surface.
2. Carefully unpack all the contents from the box. Place the
   stainless steel top face down on a rug, carton, or other protected
   surface.
3. Insert the legs into the tabletop gussets. If a leg struggles
   to go in, loosen the set screw before inserting.
4. Partially tighten the set screws on each leg. Full tightening
   will be done later.
5. On each leg, mark the desired height where the undershelf will
   be installed.
6. Slide the undershelf onto the legs and fully tighten the set
   screws on each leg.
7. Adjust the feet as needed to meet height requirements or
   compensate for uneven flooring.
8. With assistance, carefully turn the table over and remove any
   protective film.

WARNING! There is a risk of personal injury due
to sharp stainless steel edges. It is advised to wear gloves during
installation and handle the product with care.

For more information, please visit www.RegencyTablesandSinks.com

Equipment Stand with Undershelf
Assembly Instructions

TOOLS REQUIRED
Allen wrench (included)
4 Leg Table
PARTS:
A (1) Stainless Steel Top B (1) Undershelf C (4) Legs D (8) Tightening Screws
6 Leg Table
PARTS:
A (1) Stainless Steel Top B (1) Undershelf C (6) Legs D (16) Tightening Screws

A

B

C

D

Assembly Instructions
1. Make sure the assembly area is clean and on a flat secure surface. Carefully remove all the contents within the box. Place the tabletop face down on a rug, carton, or other protected surface.
2. Insert the legs into the tabletop gussets. You may need to loosen the set screw if one struggles to go in.
3. Partially tighten the set screws (fully tightening will come later).
4. On each of the legs, mark the height where you’ll be installing the undershelf.
5. Once marked, slide the shelf onto the legs and fully tighten the set screws.
6. Adjust the feet as needed to meet the height requirements or to compensate for uneven flooring.
7. With assistance, turn the table over and remove any protective film. The table is now ready to be used.
WARNING! Risk of personal injury. Stainless steel edges are sharp and can cause cuts. Wear gloves during installation and handle with care.

C A

www.RegencyTablesandSinks.com

D B

References

• Home | Regency