Swell LED Pendant
Product Information: Swell
Swell is a lighting fixture that is available in four different
variations – Swell Single, Swell String Vertical, Swell String
Horizontal, and Swell Chandelier. The assembly and installation
instructions for each variation are provided in the user manual.
The Swell Single variation operates on 120V power supply and is
designed for ceiling mounting. It comes with a mounting plate,
cover, strain relief cap, and lock nut. The fixture is available in
various colors and finishes.
Product Usage: Swell Single – Ceiling Mount 120V Assembly
Instructions
Before starting the installation process, it is recommended to
have an electrician install the ceiling mounting. Follow the below
steps to assemble and install the Swell Single:
- Loosen the strain relief cap and feed the cord through all
components. - Attach the mounting plate to the junction box.
- Connect the building wiring to the fixture wiring.
- Connect the fixture ground wire and building ground wire to the
green ground screw on the mounting plate. - Tighten the strain relief cap at the desired height
(recommended height is 6 inches or 15.24 cm). - Slide the cover up to the ceiling and secure it to the plate
with the lock nut.
If you face any difficulties during the installation process,
contact [email protected] or visit pablodesigns.com for further
assistance.
SWELL
ASSEMBLY & INSTALLATION INSTRUCTIONS
TABLE OF CONTENTS pg. 2-5……………………………………SWELL SINGLE pg. 6-9…………………….SWELL STRING VERTICAL pg. 10-13…………….SWELL STRING HORIZONTAL pg. 14-17………………………….SWELL CHANDELIER
SWELL
SINGLE
120V ASSEMBLY & INSTALLATION INSTRUCTIONS
pg. 2
CEILING MOUNT 120V ASSEMBLY INSTRUCTIONS
SWELL SINGLE
IMPORTANT: WE RECOMMEND CEILING MOUNTING BE INSTALLED BY AN ELECTRICIAN
1
LOOSEN STRAIN RELIEF CAP AND FEED CORD THROUGH ALL COMPONENTS
3 ATTACH MOUNTING PLATE TO JUNCTION BOX. CONNECT BUILDING WIRING TO FIXTURE WIRING. CONNECT FIXTURE GROUND WIRE AND BUILDING GROUND WIRE TO GREEN GROUND SCREW ON MOUNTING PLATE
STRAIN RELIEF CAP
MOUNTING PLATE
COVER
LOCK NUT
TIGHTEN STRAIN RELIEF CAP AT DESIRED HEIGHT
6″ (15.24 CM)
RECOMMENDED FOR
)
CONNECTION
TO BUILDING WIRING
BLACKG(LREEN (G)
WHITE (N)
pg. 3
CEILING MOUNT 120V ASSEMBLY INSTRUCTIONS
SWELL SINGLE
4 SLIDE COVER UP TO CEILING, THEN SECURE COVER TO PLATE WITH THE LOCK NUT
BULB TYPE PAR30SN-E26-14.5W-3000K-40° CORD LENGTH 10FT (305CM) ELECTRONIC LOW VOLTAGE DIMMER RECOMMENDED CARE INSTRUCTIONS WIPE CLEAN WITH A SOFT DAMP CLOTH. AVOID AMMONIA-BASED CLEANERS pg. 4
SWELL
SINGLE
[email protected] 888 MARIN STREET SAN FRANCISCO, CA 94124 PABLODESIGNS.COM
pg. 5
Pablo
