KSA1000 Kozi 2×2.5m Side Awning
Product Information
The Pull Out Awning 2×2.5M is a camping accessory designed for
general camping purposes in normal conditions. It is not suitable
for extreme weather conditions. The awning is manufactured by
Darche and can be found on their website at www.darche.com.au. The awning is
recommended for a two-person setup.
Awning Setup Instructions
- Step 1: Unzip the transit cover and while holding the awning,
release the hook and loop straps. - Step 2: Unroll the awning to its full length.
- Step 3: Twist to unlock and lengthen each rafter pole, do not
tighten at this stage. - Step 4: Carefully release the leg poles from within the
channel. Set each leg to the desired height then twist the leg lock
to tighten. - Step 5: Whilst holding the awning end beam with one arm, slide
each rafter arm, aligning the end pin into the end beam holes and
then twist each rafter arm lock pole to lock in position. - Step 6: Fix the awning canvas to the rafter arms using the hook
and loop straps. - Step 7: Using the pegs and guy ropes secure the awning front
beam diagonally outwards to secure the legs. - Step 8: Always set the awning up with sufficient angle to allow
water to run off and not pool on top of the awning. This can be
achieved by lowering the height of one or both of the awnings legs
to create a downward angle to encourage water to run off.
Awning Walls
A Front Wall (sold separately) can be used with this awning. To
install, slide the rope into the sail track groove and attach the
hook and loop fasteners on each side of the wall to each of the
front vertical legs. Side Walls (sold separately) can also be used
with this awning. Attach the clips at the top of the rafter pole/s
and attach the hook and loop fasteners located on the wall side to
the front vertical leg.
Awning Pack Down
- Step 1: For awning pack down, reverse the above steps. Be sure
to roll the awning material underneath itself. - Step 2: Avoid packing up the awning when wet. If the awning
must be packed away when wet, open it up to allow it to dry
completely at the earliest opportunity. Storing the awning wet for
an extended period may result in mold or other issues.
Care Instructions
Clean the awning with cold fresh water and a soft brush. Do not
use soaps or detergents on the awning. Do not expose the awning to
petrol, oils, or solvents. Ensure the awning is completely dry
before storing.
Storing Instructions
Ensure the awning is completely dry before storing. Avoid
creases when rolling up the awning. If the awning was packed away
when wet, it must be dried as soon as possible. Incorrect storage
is not covered by the warranty.
Warning and Disclaimer
Any item fixed to your vehicle’s roof can affect normal vehicle
handling. The manufacturer disclaims all responsibility in case of
accidents or damage due to improper fitment or use of this product
or issues caused by improper maintenance. This includes failure to
regularly check the tightness and condition of the fastening
hardware and mounting brackets. Darche, The wholesaler/manufacturer
shall not be liable for special, indirect incidental, or
consequential damages.
PULL OUT AWNING 2×2.5M
INSTRUCTION MANUAL
KSA1000 DARCHE.COM.AU
INSTRUCTION MANUAL
CONTENTS · 1 x Pull Out Awning with Transit Cover · 2 x L-brackets · 4 x Channel bolts, washers and nuts · 2 x Guy ropes · 2 x Pegs
Before installing and using your awning please read the instructions and warnings below. Should you have any questions or require assistance, please contact your Darche retailer or call our customer service line: 1300 367 695. Familiarise yourself with the awning, we recommend that you unpack and set up this awning at home before use. Incorrect set up or use is not covered under general warranty. Inspections: During trips regularly check that all nuts and bolts attaching your awning to your vehicle are tight and in good condition. Roof bar spacing and roof rack size should be considered when selecting your awning. The unsecured length of each side of the awning (the distance between the ends of the awning and the supplied brackets) should not exceed 600mm.
WARNING Ensure sufficient awning fall for water run-off is provided. Guy ropes can present trip hazards in day and night conditions. Ensure all guy ropes are secured and anchored correctly. Avoid using the awning in strong winds. Keep all flame and heat sources including camp fires, BBQs, etc. away from the awning. Under no circumstance should any naked flame sources or heating devices be used under or near the awning. Keep a look out for any airborne burning embers that may come into contact with the awning.
2
ATTACHING AWNING TO L-BRACKETS 1. Slide the head of the 4 x channel bolts into the mounting rail channels (two bolts in each channel),
located on the rear of the awning transit cover. 2. Position the L-brackets onto the awning using the channel bolts. 3. Align awning into desired position and tighten all nuts and bolts. 4. Recheck all nuts and bolts periodically. FITTING GUIDE Your Darche Kozi Series Awning has been designed for a universal fit with most makes and models of four wheel drives, SUV and station wagons, utes and vans. Your awning can either be mounted directly to a roof rack, roof cross bars. When mounting the awning ensure it is positioned to allow sufficient clearance for the vehicles doors to open. When fitting L-bracket to roof rack, or roof cross bars, please refer to your roof rack manual or licensed 4WD accessory fitter for assistance. When mounting to roof racks or cross bars etc, ensure the unsecured length at each end of the awning does not exceed 600mm. Mounting the L-brackets at lengths greater than 600mm from end of awning may cause excessive vibration through the awning and result in potential failure of fittings. Tip: We recommend that you go for a short drive after attaching the awning to your vehicle. Check to see if any further tightening of brackets is necessary.
DARCHE.COM.AU
INSTRUCTION MANUAL
AWNING SET UP We recommend a 2 person set up for this awning. Step 1
Unzip the transit cover and while holding the awning, release the hook and loop straps. Step 2
Unroll the awning to its full length. Step 3
Gently swing out both rafter arms from the awning’s backing, slightly past 90° away from vehicle.
4
Step 4
Twist to unlock and lengthen each rafter pole, do not tighten at this stage. Step 5
Carefully release the leg poles from within the channel. Set each leg to the desired height then twist the leg lock to tighten. Step 6
Whilst holding the awning end beam with one arm, slide each rafter arm, aligning the end pin into the end beam holes and then twist each rafter arm lock pole to lock in position.
DARCHE.COM.AU
INSTRUCTION MANUAL
Step 7
Fix the awning canvas to the rafter arms using the hook and loop straps. Step 8
Using the pegs and guy ropes secure the awning front beam diagonally outwards to secure the legs. Step 9 Always set the awning up with sufficient angle to allow water to run off and not pool on top of the awning. This can be achieved by lowering the height of one or both of the awnings legs to create a downward angle to encourage water to run off.
AWNING WALLS A Front Wall (sold separately) is available to use with this awning and can be installed by sliding the rope into the sail track groove. Attach the hook and loop fasteners on each side of the wall to each of the front vertical legs. Side Walls (sold separately) are available to use with this awning and can be installed by attaching the clips at the top of the rafter pole/s. Attach the hook and loop fasteners located on the wall side to the front vertical leg.
6
AWNING PACK DOWN 1. For awning pack down reverse the above steps. Be sure to roll the awning material underneath itself. 2. Avoid packing up the awning when wet. If the awning must be packed away when wet, open it up to allow
to dry completely at the earliest opportunity. Storing the awning wet for an extended period may result in mould or other issues.
CARE INSTRUCTIONS Clean with cold fresh water and a soft brush. Do not use soaps or detergents on the awning. Do not expose to petrol, oils or solvents. Ensure awning is completely dry before storing.
STORING Ensure awning is completely dry before storing. Avoid creases when rolling up the awning. If the awning was packed away when wet, then it must be dried as soon as possible. Incorrect storage is not covered by the warranty.
SUITABILITY This awning has been designed for general camping in normal conditions. It is not suitable for extreme weather conditions.
WARNING DISCLAIMER Any item fixed to your vehicle’s roof can affect normal vehicle handling. The manufacturer disclaims all responsibility in case of accidents or damage due to improper fitment or use of this product or issues caused by improper maintenance. This includes failure to regularly check the tightness and condition of the fastening hardware and mounting brackets. Darche, The wholesaler/manufacturer shall not be liable for special, indirect incidental or consequential damages.
DARCHE.COM.AU
INSTRUCTION MANUAL
Designed and tested in Australia for Australian conditions.
A brand by Charles Parsons. Telephone 1300 367 695 l Email: [email protected] 75 Heyington Avenue, Thomastown VIC 3074, Australia.
DARCHE: LEADERS IN OUTDOOR DESIGN. PROUDLY AUSTRALIAN.
Due to our policy of continual product development, the specifications, colours and features may vary.
V1-May 2021 DARCHE.COM.AU
Darche Outdoor Gear Australia | Shop Online – DARCHE®
