Rockville RWB70B Wakeboard 360° Swivel Tower Speakers
Specifications
- SPEAKER SIZE:5 Inches
- SPEAKER AMPLIFICATION TYPE: Passive
- IMPEDANCE: 4 Ohm
- SPEAKER TYPE: Surround Sound
- PEAK POWER HANDLING: 500 Watts
- RMS POWER HANDLING: 300 Watts
- FREQUENCY RESPONSE: 70 – 20, 000 Hz
- SOUND PRESSURE LEVEL: 96dB @ 1w/1m
- IMPEDANCE: 4 Ohms
- MOUNTING DEPTH: 9″
- PACKAGE DIMENSIONS:1 x 14.2 x 13.1 inches
- ITEM WEIGHT:12 pounds
Introduction
One 1″ Polymide Dome Neodymium Midrange Tweeter, Built-In Two-Way Crossover Network, Fully Marinized Against Salt & Fresh Water Conditions, Completely Water / Rust Resistant Rockville RWB70B Black 6. 5″ 250w Marine Wakeboard 360° Swivel Tower Speakers, Color: Black, 6. 5″ Two-Way High Fidelity Speaker System, Adjustable Nylon Mounting Bracket Reinforced With Embe
These wakeboards fit bars ranging from 1. 26″ to 2. 87″, include 65mm and 80mm screws that fit Jeep Wrangler and any roll bar, and include stainless mounting hardware that won’t rust or corrode. Terminals Are Sealed with Rubber Gaskets, Specially Tuned for PA Voice Over, Polypropylene Mica Injected Cone with Santoprene Surround, High BL Magnet Motor Structure, Y30 High Density Magnets, Oversized 1. 25″
MOUNTING BRACKET
SPEAKER CONFIGURATION
MOUNTING INSTRUCTIONS
- Release the rear clamp piece by using an Allen wrench to remove the screws.
- Place front clamp piece snug against cross bar.
- Place rear clamp piece on the other side of the crossbar,
- Insert and tighten screws ensuring a tight, snug fit.
WARNING: Make sure that the positive (and negative(speaker wires are connected to the corresponding
TERMINALS ON THE AMPLIFIER
Most speaker damage is caused by amplifiers with too much power (wattage). The proper way to set your gain is to turn your receiver volume to 75% of the max, and then slowly turn your gain up. The second you hear any slight distortion, turn it down one notch and leave it at that setting. Amps are not meant to be played with the gain up to the max. If this is the case, lower your gain slowly until you hear the amplifier stop clipping.
FAQs
I haven’t seen that you can. You can dig through their actual website and you might find them.
Cover all exposed wiring with shrink or silicone.
You will have to either buy one set of each, or paint the part that you want black….Rustoleum Professional Gloss black works well.
They are Not bluetooth. You must use the right wattage to get the optimal sound.
Please read the complete product description details, it mentions the mounting bar diameter range.
losing the bolt turn where desired and tighten.
I recommend 10gauge-14 gauge I am running 10 gauge so I don’t have any problems. Google the max load per gauges and it’ll show a chart
Look them up in the Amazon diagrams or the Rockville website.
The Allen key is included.
Yes, but not that easy….be very careful when taking it apart….it is not cut and dried. I put Polk dB652’s in a pair…it took some minor modification.
Yeah I swapped out the speakers in mine.
No you can’t. I actually tried to and no the shape of the grill and shape of the speakers are made specifically for what comes in them… steer clear they are trash. Absolutely garbage…. oh did I mention that they are trash I forget.
These are garbage I had 3 pair of them. They can’t handle 150 as a pair let alone individually. Sidenote any other speakers you see that resemble these are all made by the same manufacturer. Avoid at all cost
These speakers connect to a stereo radio and sound great.
No.
