TAP ENJ Endpin Jack Preamplifier
INSTALLATION
- Endpin jack preamp installation.
Make a hole in guitar for endpin jack. Use 12.5 mm or 1/2 inch drill bit for wood. Install the endpin jack from inside of guitar body Endpin jack preamp comes with power switch function and will turn on when plug in.
- Battery bag installation
Install battery bag with included velcro tape. Place 9V alkaline battery into battery bag. (1500hours) - Volume and tone controls installation
Make clean the surface of guitar inside with sand paper. Mount the self adhesive PCB, (volume, tone) board in location. - Optional piezo pickup installation
Make clean and flat for bottom of bridge cavity. Reduce height of bridge bar as pickup’s height. Make a hole for piezo pickup cable (use 3mm or 1/8”).
