Legacy Wall Hanger Collection
Product Information:
Finial: Pineapple
Rod Gauge: .031 1/2 into 5/8
Rod Diameter: 1.375
Wall Hanger Collection Specifications:
- Length: 3.25
Product Usage Instructions:
- With finials and end brackets attached to rod, expand the rod
to the desired length. If using a sleeve or pocket on the back of
the rug, tapestry, or quilt, separate rods and slide into the
sleeve or pocket first. - Hold the rod in the desired position against the wall and mark
the position of holes in the left end bracket. - While supporting the right side, install the left end bracket
using the provided screws. Wall anchors must be used if screws are
not installed into a stud. - Locate the position of the right end bracket by leveling the
rod and expanding it to the desired length. Install the right end
bracket into the wall. - After end brackets are installed, place center support brackets
into desired positions and install. Wall anchors must be used if
screws are not installed into a stud. - If using clips, attach them to the rug, tapestry, or quilt and
secure them in place by tightening the disc. Both 1/2 and 5/8 clips
are provided and should be used on corresponding rods. Place clips
over the rod.
Note: All parts are lacquer coated to resist tarnishing.
Do not use brass cleaner or other abrasives. To clean, simply wipe
with a soft dry cloth. Periodically check and tighten all screws
and hardware.
FINIAL
Pineapple
ROD GAUGE ROD DIAMETER
Legacy®
WALL HANGER COLLECTION SPECIFICATIONS
LENGTH
3 1/4″
.031″ 1/2″ into 5/8″
1.375″
3.25″
Zoroufy® Stair Rods slide into each bracket approximately ½”. Finials attach to the bracket.
INSTALLATION INSTRUCTIONS
1. With finials and end brackets attached to rod, expand rod to desired length. If using a sleeve or pocket on the back of the rug, tapestry, or quilt, separate rods and slide into sleeve or pocket first.
2. Hold rod in desired position against wall and mark position of holes in the left end bracket.
3. While supporting the ride side, install the left end bracket using provided screws. Wall anchors must be used if screws are not installed into a stud.
4. Located position of the right end bracket by leveling rod and expanding to desired length. Install the right end bracket into wall.
5. After end brackets are installed, place center support brackets into desired positions and install. Wall anchors must be used if screws are not installed into a stud.
6. If using clips, attach to the rug, tapestry, or quilt and secure in place by tighting the disc. Both 1/2″ and 5/8″ are provided and should be used on corresponding rods. Place clips over the rod.
ALL PARTS ARE LACQUER COATED TO RESIST TARNISHING. DO NOT USE BRASS CLEANER OR OTHER ABRASIVES. TO CLEAN, SIMPLY WIPE WITH A SOFT DRY CLOTH. PERIODICALLY CHECK AND TIGHTEN ALL SCREWS AND HARDWARE.
2140 W. GREENVIEW DR. SUITE 5, MIDDLETON, WI 53562-0345 · 800-762-1525 · [email protected] · www.zoroufy.com
Stair Rods | Stair Carpet Rods | Zoroufy Official Site |
